Bedienungsanleitung Bauknecht BB8760C (Seite 6 von 9) (Englisch)

703838

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

FIRST TIME USE

POWER MANAGEMENT

At the time of purchase, the hob is set to the maximum possible power.

Adjust the setting in relation to the limits of the electrical system in your

home as described in the following paragraph.

To set the power of the hob:

Once you have connected the device to the mains power supply, you

can set the power level within 60 seconds.

Press the far right timer “+“ button for at least 5 seconds. The display shows

Press the

3 sec

button until the last power level selected appears.

Use the “+“

and

“−“

buttons to select the desired power level. The power

levels available are: 2.5 kW – 4.0 kW – 6.0 kW – 7.2 kW.

Conrm by pressing

3 sec

The power level selected will stay in the memory even if the power supply

is interrupted.

To change the power level, disconnect the appliance from the mains for at

least 60 seconds, then plug it back in and repeat the steps above.

If an error occurs during the setting sequence, the

symbol will appear,

and you will hear a beep. If this happens, repeat the operation.

If the error persists, contact the After-Sales Service.

ACOUSTIC SIGNAL ON / OFF

To switch the acoustic signal on/o:

• Switch on the hob.

• Press the “P“ button of the rst keypad at the top left for 5 seconds.

Any alarms set will remain active.

DEMO MODE

To switch the demo mode on and o:

• Connect the hob to the power supply;

• Within the rst minute, press the quick heating button “P“ of the

bottom left keypad for 5 seconds (as shown below).

ACCESSORIES

POTS AND PANS

Only use pots and pans made from ferromagnetic

material which are suitable for use with induction hobs:

• enamelled steel

• cast iron

• special pots and pans in stainless steel, suitable

for induction cooking

To determine whether a pot is suitable, check for the

symbol (usually

stamped on the bottom). A magnet may be used to check whether pots are

magnetic.

The quality and the structure of the pot base can alter cooking performance.

Some indications for the diameter of the base do not correspond to the

actual diameter of the ferromagnetic surface.

Some pots and pans have only a part of the bottom in ferromagnetic

material, with parts in another material that is not suitable for induction

cooking. These areas may heat up at dierent levels or with lower

temperatures. In certain cases, where the bottom is made mainly of

non-ferromagnetic materials, the hob might not recognise the pan and

therefore not switch on the cooking zone.

To ensure optimum eciency, always use pots and pans with a at bottom

that distributes the heat evenly. If the bottom is uneven, this will aect

power and heat conduction.

NOOK

Empty pots or pots with a thin base

Do not use empty pots or pans when the hob is on. The hob is equipped with

an internal safety system that constantly monitors the temperature, activating

the “automatic o“ function where high temperatures are detected. When

used with empty pots or pots with thin bases, the temperature may rise very

quickly, and the “automatic o“ function may not be triggered immediately,

damaging the pan or the hob surface. If this occurs, do not touch anything,

and wait for all components to cool down.

If any error messages appear, call the service centre.

Minimum diameter of pot/pan base for the dierent cooking areas

To ensure that the hob functions properly, the pot must cover one or

more of the reference points indicated on the surface of the hob, and

must be of a suitable minimum diameter.

Always use the cooking zone that best corresponds to the diameter of

the bottom of the pan.

120 mm 200 mm

ADAPTER FOR POTS/PANS UNSUITABLE FOR INDUCTION

Using this accessory makes it possible to use pots and pans that are not

suitable for induction hobs. It is important to bear in mind that using it

aects eciency and consequently the time needed to heat food. Its

use should be limited because the temperatures reached on its surface

depend signicantly on the pot/pan used, its atness and the type of

food being cooked. Using a pot or pan with a smaller diameter than the

adapter disc may cause heat to build up that is not transmitted to the

pot or pan and this could blacken both the hob and the disc. Adapt the

diameter of your pots/pans and the hob to the diameter of the adapter.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht BB8760C Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht BB8760C

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info