Bedienungsanleitung BEKO WMY 71423 LMB3 (Seite 72 von 75) (Deutsch, Englisch, Holländisch, Französisch)

579385

Zoom out

Zoom in

Vorherige Seite

1/75

Nächste Seite

72 / EN

Washing Machine / User’s Manual

4.17 Your machine is equipped with a

“Standby Mode”

In case of not starting any programme or waiting without

making any other operation when the machine is turned

on by On/Off button and while it is in selection step or if

no other operation is performed approximately 2 minutes

after the programme you selected has come to an end, your

machine will automatically switch to energy saving mode.

Display brightness will decrease. In case of rotating the

Programme Selection knob or pressing any button, lights will

restore to their previous condition. This is not a fault.

Cleaning programme, use Cottons-90 programme and

select

Additional Water or Extra Rinse auxiliary functions

as well. Run the programme without any laundry in the

machine. Before starting the programme, put max. 100

g of powder anti-limescale into the main wash detergent

compartment(compartment nr. 2). If the anti-limescale is in

tablet form, put only one tablet into compartment nr. 2. Dry

the inside of the bellow with a clean piece of cloth after the

programme has come to an end.

Repeat Drum Cleaning process in every 2 months.

Use an anti-limescale suitable for the washing

machines.

After every washing check that no foreign substance is left

in the drum.

If the holes on the bellow shown in the figure is blocked,

open the holes using a toothpick.

Foreign metal substances will cause rust stains in the

drum. Clean the stains on the drum surface by using

cleaning agents for stainless steel. Never use steel wool

or wire wool.

WARNING: Never use sponge or scrub materials.

These will damage the painted and plastic surfaces.

5.3 Cleaning the body and control panel

Wipe the body of the machine with soapy water or non-

corrosive mild gel detergents as necessary, and dry with a

soft cloth.

Use only a soft and damp cloth to clean the control panel.

5.4 Cleaning the water intake filters

There is a filter at the end of each water intake valve at the

rear of the machine and also at the end of each water intake

hose where they are connected to the tap. These filters

prevent foreign substances and dirt in the water to enter the

washing machine. Filters should be cleaned as they do get

dirty.

1 Close the taps.

2 Remove the nuts of the water intake hoses to access

the filters on the water intake valves. Clean them with an

appropriate brush. If the filters are too dirty, take them out

by means of pliers and clean them.

3 Take out the filters on the flat ends of the water intake

hoses together with the gaskets and clean thoroughly

under running water.

5 Maintenance and cleaning

Service life of the product extends and frequently faced

problems decrease if cleaned at regular intervals.

5.1 Cleaning the detergent drawer

Clean the detergent drawer at regular intervals (every

4-5 washing cycles) as shown below in order to prevent

accumulation of powder detergent in time.

Lift the rear part of the siphon to remove it as illustrated.

If more than normal amount of water and softener

mixture starts to gather in the softener compartment,

clean the siphon.

2 Wash the detergent drawer and the siphon with plenty of

lukewarm water in a washbasin. Wear protective gloves

or use an appropriate brush to avoid touching of the

residues in the drawer with your skin when cleaning.

3 After cleaning, replace the siphon back to its seating and

push its front section downwards to make sure that the

locking tab engages.

5.2 Cleaning the loading door and the drum

Residues of softener, detergent and dirt may accumulate in

your machine in time and may cause unpleasant odours and

washing complaints. To avoid this, use the

Drum Cleaning

programme. If your machine is not featured with

Drum

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMY 71423 LMB3 Seite 72

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info