Bedienungsanleitung BEKO WMY 81483 LMB2 (Seite 32 von 36) (Deutsch, Englisch)

579431

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

32 / EN

Washing Machine / User’s Manual

indicator and Start / Stop LED continue to flash.

Also, when the loading door is ready to be opened, Loading

Door light will also turn off in addition to the programme step

light.

4.11.2 Changing the auxiliary function, speed

and temperature

Depending on the step the programme has reached, you

can cancel or select the auxiliary functions. See, "Auxiliary

function selection".

You can also change the speed and temperature settings.

See, "Spin speed selection" and "Temperature selection".

If no change is allowed, the relevant light will flash

for 3 times.

4.11.3 Adding or taking out laundry

1. Press the Start / Pause button to switch the machine

to pause mode. The programme follow-up light of the

relevant step during which the machine was switched into

the pause mode will flash.

2. Wait until the Loading Door can be opened.

3. Open the Loading Door and add or take out the laundry.

4. Close the Loading Door.

4. Make changes in auxiliary functions, temperature and

speed settings if necessary.

6. Press Start/Pause button to start the machine.

4.12 Child Lock

Use Child Lock function to prevent children from tampering

with the machine. Thus you can avoid any changes in a

running programme.

You can switch on and off the machine with On

/ Off

button when the Child Lock is active. When

you switch on the machine again, programme will

resume from where it has stopped.

4.12.1 To activate the child lock:

1. Press and hold Auxiliary Function button 2 for 3

seconds. In the programme selection display on the panel,

"Child lock enabled" light will turn on. You can release

Auxiliary Function button 2

when this warning is

displayed.

4.12.2 To deactivate the child lock:

1. Press and hold Auxiliary Function button 2 for 3

seconds. In the programme selection display on the panel,

"Child lock enabled" light will turn off.

4.13 Canceling the programme

The programme is cancelled when the machine is turned off

and on again. Press and hold

On / Off button for 3 seconds.

If you press On / Off button when the Child Lock is

enabled, the programme will not be cancelled. You

should cancel the Child Lock first.

If you want to open the loading door after you have

cancelled the programme but it is not possible

to open the loading door since the water level in

the machine is above the loading door opening,

then turn the

Programme Selection knob to

Pump+Spin programme and discharge the water

in the machine.

4.14 End of programme

End LED appears on the display when the programme is

completed.

If you do not press any button for 10 minutes, the machine

will switch to OFF mode. Display and all indicators are turned

off.

Completed programme steps will be displayed if you press

On / Off button.

4.15 Your machine features "Standby Mode".

After you switch on your machine with On-Off button, if no

program is started or no other procedure is performed at

the selection step or no action is taken within approx. 10

minutes after the selected program ends, your machine will

switch to OFF mode automatically. Display and all indicators

are turned off. Selected programme data will be displayed

if you press On / Off button. Before you start the program,

check the accuracy of your selections. If necessary, repeat

them. This is not an error.

5 Maintenance and cleaning

Service life of the product extends and frequently faced

problems decrease if cleaned at regular intervals.

5.1 Cleaning the detergent drawer

Clean the detergent drawer at regular intervals (every

4-5 washing cycles) as shown below in order to prevent

accumulation of powder detergent in time.

Lift the rear part of the siphon to remove it as illustrated.

If more than normal amount of water and softener

mixture starts to gather in the softener compartment,

clean the siphon.

2 Wash the detergent drawer and the siphon with plenty of

lukewarm water in a washbasin. Wear protective gloves

or use an appropriate brush to avoid touching of the

residues in the drawer with your skin when cleaning.

3 After cleaning, replace the siphon back to its seating and

push its front section downwards to make sure that the

locking tab engages.

5.2 Cleaning the loading door and the drum

Residues of softener, detergent and dirt may accumulate in

your machine in time and may cause unpleasant odours and

washing complaints. To avoid this, use the

Drum Cleaning

programme. If your machine is not featured with

Drum

Cleaning

programme, use Cottons-90 programme and

select

Additional Water or Extra Rinse auxiliary functions

as well. Run the programme without any laundry in the

machine. Before starting the programme, put max. 100

g of powder anti-limescale into the main wash detergent

compartment(compartment nr. 2). If the anti-limescale is in

tablet form, put only one tablet into compartment nr. 2. Dry

the inside of the bellow with a clean piece of cloth after the

programme has come to an end.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMY 81483 LMB2 Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BEKO WMY 81483 LMB2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info