Bedienungsanleitung Lowrance GPS Antenna (Seite 2 von 2) (Englisch)

599463

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

38 mm (1.50")

90 mm (3.54")

38 mm (1.50")

14 Threads per inch

85 mm (3.35")

132.5 mm (5.22")

123 mm (4.84")

Dimensions

Connection

120

12 VDC

B C

H I

1.22 m (4 ft)

Specications

General

Receiver Type L1, C/A code, 1.575 GHz Frequency/L2 C/A

code, 1.602 GHz Frequency

Channels 32 channels

Position Update Rate Up to 10 Hz (1,5,10)

Horizontal Accuracy 3 m (9.8 ft)

Heading Accuracy +/- 3°

Rate of Turn +/- 3°

Pitch / Roll Accuracy @30 degrees 1 grade error

Cold Start 50 sec

Start-Up Time 3 sec

Satellite Reacquisition 5 sec

Environmental

Operating Temperature -25° C to +60° C

Storage Temperature -40° C to +85° C

Splash Proof IPX7

Humidity 40° C, 93%RH, operating

Electrical

Input Voltage 9 V DC - 18 V DC

Reverse Polarity Protection Yes

Power Consumption < than 2w

Current Consumption < 100 mA @ 12 V DC

Dimensions 90 mm (diam) x 38mm (height)

3.54” (diam) x 1.50” (height)

Weight 0.14 Kg (0.3 lbs) aprox

Power/Data Cable NMEA 2000 thru NMEA 2000 network

Antenna Connector NMEA 2000 Micro C

Mounting Flush mount / Standard Pole Mount

Communications

Data I/O Protocol NMEA 2000

NMEA 2000 PGNs

PGN Number PGN Title

126992 System Time

129025 Position, Rapid Update

129026 COG & SOG RU

129029 Position Data

129539 GNS DOP

129540 GNS Satellites in view

127258 Magnetic Variation

127250 Compass Heading (Vessel Heading)

127251 Rate of Turn

127257 Attitude

Compliance Statements

Lowrance Point-1, Simrad GS25 and B&G ZG100

Meet the technical standards in accordance with Part 15.103 of the FCC Rules.

Comply with CE under R&TTE directive 1999/5/EC

Comply with the requirements of level 2 devices of the Radio-communications (Elec-

tromagnetic Compatibility) standard 2008.

The relevant Declaration of Conformity is available in the following website under

model documentation section:

http://www.lowrance.com/

http://www.simrad-yachting.com

http://www.bandg.com

A Chart Plotter

B Lowrance Point -1 or Baja has molded cable 1.2 m (4 ft)

C Simrad GS25 or B&G ZG100 : Requires NMEA 2000 Drop Cable (D)

D NMEA 2000 drop cable max length 4.55 m (15 ft)

E 120 Ohm Terminator (Male)

F 120 Ohm Terminator (Female)

G Fuse (5 Amp)

H Switch

I NMEA 2000 Power cable 1.8 m (6 ft)

J 12 VDC Power supply

60 mm

Lowrance LGC-5000

Cable can side exit

Requres 0 mm of surface thickness

B&G ZG100

Simrad GS-25

Heading sensor calibration

The built in heading sensor will need to be calibrated before use

to compensate for local magnetic ﬁelds on your vessel for accurate

chart with radar overlay.

Auto Calibrate mode

Before the heading sensor calibration is started, make sure that

there is enough open water around for the vessel to make multiple

full turns. The calibration should be done in calm sea conditions

and with minimal wind to obtain best results.

A Disconnect then re-connect the sensors NMEA 2000 cable.

B Make two consecutive turns of 360 degrees. The completion

of these two turns automatically activates the Auto Calibration

procedure.

C Continue with a smooth third turn and a quarter (of at least 390

degrees) within 2 to 5 minutes, to complete the calibration.

D Calibration should be complete. If the time is outside the limits,

the calibration is void and the radar overlay may not appear

accurate on your chart. Repeat steps A-D again.

C D

Calibration from a Multifunction Display

Calibration can be performed from a compatible Multifunction

Display, instrument display or autopilot controller. (Please refer to

the operator/installation manual).

Multiple heading sensors on the network

WARNING:

If there are two Point-1 units (or an additional heading sensor) on

the network, the Point-1 antenna(s) will stop sending heading

information.

This does not apply to Simrad GS25 and B&G ZG100.

Heading sensor application

This sensor includes an electronic heading sensor to provide chart

stabilization, course over ground at low speeds, and overlay of radar

on charts.



Acceptable performance for the application



A rate stabilized heading sensor such as RC42N

will provide the most robust performance for

demanding applications.

Point-1

GS25

ZG100

RC42N Rate compass

MARPA

Radar Overlay

 

MARPA

Radar Overlay





MARPA

Radar Overlay





Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Lowrance GPS Antenna Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info