450356
2
Zoom out
Zoom in
Vorherige Seite
1/13
Nächste Seite
58
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check
After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use the
washing machine. Contact After-Sales Service or
your local retailer
Check that the accessories and supplied parts are
all present
Keep the packing material (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous
2.Remove the transport bolts
The washing machine is fitted with transport
bolts to avoid any possible damage to the interior
during transport. Before using the washing
machine, it is imperative that the transport bolts
are removed
3.Install the washing machine
Remove the protective foil from the control
panel
Move the appliance without lifting it by the
worktop
Install the appliance on a solid and level floor
surface, preferably in a corner of the room
Make sure that all four feet are resting firmly on
the floor and check that the appliance is perfectly
level (use a spirit level)
4.Water inlet
Connect the water supply inlet hose in
accordance with regulations of your local water
company
Water inlet: Cold water only
Tap: 3/4” threaded hose connection
Water Pressure
(flow pressure): 100-1000 kPa (1-10 bar)
5.Drain hose
Connect the drain hose to the siphon or hook it
over the edge of a sink by means of the “U” bend
supplied
If the washing machine is connected to a built-in
pumping out system, ensure that the latter is
equipped with a vent to avoid simultaneous loading
and draining of water (siphoning effect)
6.Electrical connections
Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and local safety
regulations
Data concerning voltage, consumption and fuses
are located on the inside of the appliance door
The appliance must be connected to the mains
exclusively by means of a socket with an earth
connection in accordance with established
regulations. The washing machine must be
earthed by law. The manufacturer declines all
liability for damage to property or injury to
persons or animals due to non-compliance with
the directions given above
Do not use extension leads or multi sockets
Before any maintenance on the washing machine
disconnect it from the mains supply
Access to the mains plug or to disconnection
from mains supply via a double-pole switch must
be ensured at all times following the installation
Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service
Mains cable replacement is only to be carried out
by After-Sales Service
The washing machine must only be used in the
household for the prescribed uses
Minimum housing dimensions:
Width: 600 mm
Height: 825 mm
Depth: 600 mm
3gb05612.fm Page 58 Saturday, June 5, 2004 4:16 PM
Black process 45.0° 100.0 LPI
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Whirlpool AWM 008 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info