721699
50
Zoom out
Zoom in
Vorherige Seite
1/54
Nächste Seite
49
Troubleshooting
Refer to the symptoms and measures listed below before sending the projector for
repairs. If the problem persists, contact your local reseller or service center. Please
refer to "LED Indicator Messages" as well.
# Problem Solution
1
No picture and no sound or
projector does not start.
Projector power cord is not plugged into the wall outlet.
Power to the external connected devices is off.
The selected input mode is wrong.
Cables are incorrectly connected to the projector.
Remote control battery has run out.
External output has not been set when connecting
notebook computer
If you turn on the connected device prior to the projector,
pictures are displayed incorrectly.
2
Sound is heard but no picture
appears (or picture is dark).
Cables are incorrectly connected to the projector.
"Brightness" is set to minimum position.
Depending on the computer you are using, an image may
not be projected unless the signal output setting of the
computer is switched to the external output. Refer to the
computer's operation manual for how to switch its signal
output settings.
Do you use 3D viewing mode ?
When temperature inside the projector increases, the
cooling fan runs faster. If this state continues, the picture
may become dark.
3 Color is faded or poor.
Image adjustments are incorrectly set.
Make adjustments of "Color" and "Tint" in "PICTURE >
Advanced" and lower the "BrilliantColor™" value.
4 Picture is blurred; noise appears.
• Adjust the focus.
The projection distance exceeds the focus range.
There is fog on the projection window. If the projector is
carried from a cold room into a warm room, or if it is
suddenly heated, condensation may form on the surface
of the projection window and the image will become
blurred. Set up the projector at least one hour before it is
to be used. If condensation should form, remove the
power cord from the wall outlet and wait for it to clear.
(Computer Input only)
Perform Synchronization Adjustments ("Frequency" and
"Phase" Adjustment)
Noise may appear depending on the computer.
50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Acer FL-320 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info