Water inlet
Connect the water
inlet hose to a tap
with a 3/4" thread.
The other end of
the inlet hose which
connects to the
machine can be
turned in any direc-
tion. Simply loosen
the fitting, rotate the hose and retighten the fitting, making sure there
are no water leaks.
The inlet hose must not be lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase a new, longer hose spe-
cially designed for this type of use.
WATER STOP
The inlet hose is provided with a water stop
device, which protects against damage caused
by water leaks in the hose which could devel-
op due to natural ageing of the hose. This
fault is shown by a red sector in the window
“A”. Should this occur, turn the water tap off
and refer to your Service Centre to replace the
hose.
Water drainage
The end of the drain hose can be positioned
in three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the machine
is emptying.
This could be done by tying it to the tap
with a piece of string or attaching it to the
wall.
In a sink drain pipe branch. This branch must be above the trap so that
the bend is at least 60 cm above the ground.
42
Installation
