5 ENGLISH
TECHNICAL DATA
Connecting voltage ..................12/24 V
Voltage range .........................7,2-18 V
Quick charge current .............2,0-3,0 A
Maintaining charge .......................50 mA
Battery charging time at: 12 V
1,4 Ah ............................approx 35 min
1,7 Ah ............................approx 45 min
2,0 Ah ............................approx 55 min
2,4 Ah ............................approx 65 min
Weight without cable ..................490 g
SAFETY INSTRUCTIONS
Please pay attention to the safety instructions in the attached
leaflet!
Do not dispose of used battery packs in the household refuse
or by burning them. AEG Distributors offer to retrieve old
batteries to protect our environment.
Do not store the battery pack together with metal objects
(short circuit risk).
Use only System 3000 chargers for charging System 3000
battery packs. Do not use battery packs from other systems.
The following battery packs can be charged with this charger:
voltage battery rating No. of
(NiCd) (of storage battery) battery
cells
7,2 V B 7.2-range
1,4 Ah 6
9,6 V B 9.6-range
1,4 Ah 8
12 V B 12-range
1,2 Ah 10
14,4 V B 14.4-range
1,4 Ah 12
18 V B 18-range
1,4 Ah 15
Do not try to charge non-chargeable batteries with this
charger.
No metal parts must be allowed to enter the battery section of
the charger (short circuit risk).
Never break open battery packs and chargers and store only
in dry rooms. Keep dry at all times.
Never charge a damaged battery pack. Replace by a new
one.
Before use check machine, cable, and plug for any damages
or material fatigue. Repairs should only be carried out by
authorised Service Agents.
SPECIFIED CONDITIONS OF USE
The quick charger can charge AEG batteries from
7.2 V to 18 V.
Do not use this product in any other way as stated for normal
use.
POWER SUPPLY
For mobile use, the charger van be connected with an on-
board network (car, lorry, boat/ship, solarstation) with a d.c.
voltage of 12 V/24 V. The charger recognises the voltage,
manual adjustment is not necessary.
BATTERIES
New battery packs reach full loading capacity after 4 - 5
chargings and dischargings. Battery packs which have not
been used for some time should be recharged before use.
CHARACTERISTICS
After inserting the battery into the reception of the charger the
battery will automatically be charged (control lamp is
illuminated continuously)
If the battery is too hot (over approx .45°C) the charger
switches to maintenance charge. Remove battery, allow to
cool down and insert again.
If the battery is too cold (less than approx. 0°C) no charging
takes place. After warming up of the battery charging takes up
automatically; the battery can stay in the charger.
The battery’s charging time is between 10 min and 60 min,
depending on the state of discharge.
The battery can be stored permanently in the charger without
the danger of being overcharged.
During the charging of battery a discharge protection that the
car battery will only discharge as much as is necessary and
just start the car. If the battery voltage increases under 10,5 V
the discharge protection will interrupt the charge process ->
the charge control lamp is switched off.
MAINTENANCE
If the supply cord of this appliance is damaged, it must only
be replaced by a repair shop appointed by the manufacturer,
because special purpose tools are required
Use only AEG accessories and spare parts. Should
components need to be replaced which have not been
described, please contact one of our AEG service agents (see
our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered.
Please state the ten-digit No. as well as the machine type
printed on the label and order the drawing at your local
service agents or directly at: AEG Elektrowerkzeuge,
Max-Eyth-Straße 10, D-71364 Winnenden, Germany.
SYMBOLS
Do not touch the tool with conducting objects.
Please read the instructions carefully before
starting the machine.
