496440
15
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
En
ENGLISH
15
DOLBY SURROUND AND DTS
SURROUND
ADJUSTING SPEAKER LEVEL
BALANCE
SUBWOOFER
+,-
CENTER
+,-
REAR +,-
BALANCE
BALANCE
JOG +,-
MANUAL
SELECT
The unit is equipped with a built-in test signal generator called a
noise sequencer for easy balance adjustment of all five channels.
The sequencer outputs a noise signal that “travels” from channel
to channel, enabling the simple adjustment of sound level to
achieve the same apparent loudness, at your listening position,
from each channel.
Preparation
Before adjusting the speaker level balance, be sure to set
the speaker size, distance and existance correctly.
Before adjusting the speaker level balance, turn off the DSP
surround system.
Operate the unit while playing the source recorded in Dolby
Digital surround or Dolby Pro Logic.
1Turn SURROUND on.
2 Press and hold MANUAL SELECT on the remote
control until “L” of “L/R 0dB” starts to flash.
A noise signal is sent to each channel in turn at the interval of
2 seconds as follows:
L/R 0dB
C 0dB
L/R 0dB
S 0dB
S 0dB
*L or R flashes to indicate one of the front speakers from
which the noise signal is output.
3 Adjust the sound level of the center and surround
speakers.
While “C” or “S” flashes in the display, press JOG + or - on
the remote control so that the sound level of the center or
surround speakers matches that of the front speakers.
The blance of the front speakers can be adjusted as well while
L/R” is displayed.
4 Press MANUAL SELECT again to stop the noise
signal.
NOTE
When the noise signal cycles through all the speakers for ten
times, the noise singal stops automatically.
When the center speaker and/or surround speakers are set to
NONE”, their level balance cannot be adjusted. (“C 0dB” and “S
0dB” are not displayed.)
About the channels
The left and right front speakers create the stereo effect.
The center speaker helps precise sound positioning over a broad
sound field.
The surround speakers enhance the “depth” of the sound field.
CHANGING SPEAKER VOLUME
TEMPORARILY
According to the software played or your preference, you can
change the sub woofer, center speaker and surround speakers
volume temporarily.
Press SUBWOOFER +/-, CENTER +/- or REAR +/-
on the remote control.
Each speaker level can be changed within the range from –10
dB to +10 dB at 1 dB steps.
To restore the volume and balance to the default value
Press and hold BALANCE until “LVL RESET” is displayed.
All the speaker volume as well as the left and right balance of
the front and surround speakers are reset to the default value
(0 dB).
(Left front speaker)*
(Center speaker)
(Right front speaker)*
(Right surround speaker)
(Left surround speaker)
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Aiwa AV-NW31 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info