Bedienungsanleitung Aiwa NSX-AJ22 (Seite 7 von 62) (Englisch, Französisch, Spanisch)

496532

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

ENGLISH

SETTING THE CLOCK

Press CLOCK while pressing SHIFT on the remote

control.

When using the unit, press

a while the power is off.

The clock is displayed. (The “:” between the hours and minutes

flashes.)

Within 4 seconds, turn MULTI JOG to designate

the hour and the minute.

Turning MULTI JOG changes both the hour and the minute.

f or g is also available in place of MULTI JOG. Holding

these buttons down will vary the time rapidly.

Press ENTER or a.

The clock starts from 00 seconds.

To restore an original clock setting

Press CLOCK while pressing SHIFT on the remote control before

completing step 3 to restore the previous time setting. This

cancels any new setting.

To view the clock when another display is in the display

Press CLOCK while pressing SHIFT on the remote control. The

time is displayed for 4 seconds and then the original display

reappears. However, the clock cannot be displayed during

recording.

To switch to the 24-hour standard

Press CLOCK while pressing SHIFT on the remote control and

then press s within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

In the 12-hour standard, “AM 12:00” indicates midnight and

“PM12:00” indicates noon.

If the clock display flashes

If the display flashes when the clock is displayed, it indicates

that the clock has stopped due to a power failure or the removal

of the power cord. The current time needs to be reset.

If the power-economizing mode (page 6) is on, the unit blacks

out when the power is turned off. To view the clock, press CLOCK

while pressing SHIFT on the remote control so that the time is

displayed for 4 seconds.

PREPARATIONS

REMOTE CONTROL

Inserting batteries

Detach the battery cover on the rear of the remote control and

insert two R6 (size AA) batteries.

When to replace the batteries

The maximum operational distance between the remote control

and the sensor on the main unit should be approximately 5 meters

(16 feet). When this distance decreases, replace the batteries

with new ones.

To use SHIFT on the remote control

Buttons 1 have two different functions. One of these functions

is indicated on the button, and the other on the plate above the

button.

To use the function on the button, simply press the button.

To use the function on the plate above the button, press the button

while pressing SHIFT.

To use FUNCTION on the remote control

FUNCTION substitutes for the function buttons (TAPE DECK

1/2, TUNER BAND, VIDEO/AUX, CD) on the main unit.

Each time FUNCTION is pressed, the next function is selected

cyclically. When tapes are inserted in both decks, each deck is

selected with FUNCTION.

•“4” and “5” of DISC DIRECT PLAY on the remote control cannot

be used on this system.

• If the remote control is not going to be used for an extended

period of time, remove the batteries to prevent possible

electrolyte leakage.

• The remote control may not operate correctly when:

- The line of sight between the remote control and the remote

sensor inside the display window is exposed to intense light,

such as direct sunlight

- Other remote controls are used nearby (those of a television,

etc.)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Aiwa NSX-AJ22 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info