Bedienungsanleitung Albrecht AE 6199 (Seite 6 von 16) (Englisch)

567466

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Installation of the Radio

You can either operate your ALBRECHT AE 6199 in the car or at home as a base station.

For installation as a mobile station in the car, a mounting bracket is enclosed. Mount the set

in such a way that it is not exposed to direct sunlight if possible, as this would lead to an

increase in the temperature and can decrease the (set’s) working life. The set should also

not be installed near a heater. Mount the set in such a way that it is exposed to as little

vibration as possible.

The mounting bracket should be attached to the dashboard, the tunnel slot or to any other

suitable place using the enclosed tapping screws. Do not install the set in a place where it

could cause injuries in the case of an accident (be careful to ensure free leg movement).

Take care not to damage any underlying wires during installation!

Then insert the radio into the mounting bracket. Secure the set with the large knurled screws

(using the enclosed washers) firmly at the required angle.

Also mount the microphone hanger using the enclosed screws in an easily-accessible place.

In order to prevent interference to the vehicle electronics from transmission in the vehicle,

please make sure to take any mounting instructions from the vehicle manufacturer for radios

and antennas into account.

Please note: European directives allow the car or truck manufacturers to decide, where, or

even whether or not private radio transceivers may be operated in their cars, this is also

valid for antenna installations. Please install Your mobile CB station only in accordance to

car manufacturer’s installation instructions.

Power Supply

Your AE 6199 receives power from the 2 pin fixed power cable.

The red and black wires in the cable are for the power supply. The cable has a looped-in

fuse. Any new installed radio starts (may depend on the country of sales) on CH 9 AM in the

German country setting (80/40), when it will be connected for the first time to 12 V power.

You can choose from two methods when connecting to the power supply (red and black):

Example 1

The radio should be able to be switched on and off at any time using the volume /

on/off switch. The radio always keeps the last used settings in memory.

Connect up the red to the positive pole on the vehicle battery (or elsewhere in the

vehicle’s electrical system with permanent plus) or to a 12 volt power unit.

Connect up the black wire to the negative pole on the vehicle battery or the power

unit or to a well-conductive part of the car body. (Not all body ground positions are

good for radio communication- in most cases the battery Minus is the best

connecting position)

Example 2

The set should be automatically be switched on and off with the ignition switch of

the car. The radio will keep always the last used settings in memory, even at longer

power disconnection.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Albrecht AE 6199 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Albrecht AE 6199

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info