Bedienungsanleitung Albrecht bt 1000 bluetooth (Seite 5 von 7) (Englisch)

228499

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

then switch it on again and press all 3 keys simultaneously for about 3 seconds. Now you can hear a short

melody for confirmation. Release the keys. Finally, switch the headset 1 x off and on again with the slide

switch. Your Bluetooth

headset is ready for pairing with your mobile phone.

On the mobile phone’s side You start the pairing procedure as described in the user manual of Your phone.

Within the setup menu Your phone will search for active Bluetooth

devices in Your communication range.

Your headset will be detected as „BT 1000 by Albrecht“. Mobile phone and Bluetooth

headset will

exchange data, which contain among others also the individual serial numbers of all devices. So it is ensured

that a communication can only start between registered partners. After registration of Your Bluetooth

headset You will be asked for a PIN code. Please use following PIN code:

1234

(if Your headset user manual or gift box should contain a card with another PIN code, please use this PIN

code instead of 1234)

Note: All major mobile phone manufacturers update the Bluetooth

pairing procedures from time to time

together with their software releases. The mobile phone distributors may assist you. New releases can be

found on the internet pages of the mobile phone manufacturers. The attached menu was last updated

beginning of 2003.

Accept incoming calls and adjust receiving volume

• You can transfer incoming calls by pressing the start-stop button at Your BT 1000 Bluetooth

headset. The switching from mobile phone to the headset will take a small moment only. .

• Adjust the earphone volume by pressing the volume buttons or of the headset according to

your needs. You may also feel the volume keys with your fingers: The key with 1 dot reduces the

volume, while the key with 2 dots will increase volume.

Important Note:

If Your Bluetooth

headset should be moved away from the mobile phone outside the communication range,

it may be necessary to re-establish the connection later again. To reconnect Your headset, press the start-stop

key of Your headset. If this should not help to reconnect the headset to Your phone, it may be necessary

in some cases to switch the headset 1 x off and on again, before pressing the start-stop button can re-

establish the communication.

Reset procedure to factory default status

A reset procedure can help to re-established a lost connection between the Bluetooth

headset and the

cellular phone or any other device to which You have paired Your headset. This will always be necessary

before pairing the headset with another phone, or sometimes, after a data error or any other malfunction

should have stopped Your system from running. Especially if You should wish to connect Your mobile

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Albrecht bt 1000 bluetooth Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Albrecht bt 1000 bluetooth

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info