675384
24
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
21
If you have difficulty with your phone, please try the suggestions listed below. As a general
rule, if a problem occurs, remove the batteries from all the wireless microphone units in your
installation for about 1 minute, and then disconnect and reconnect the power supply to the
base and reinstall the batteries carefully.
The conference phone
doesn’t work.
Make sure all cables are plugged in correctly and the
batteries are installed and charged. After use, remember
to put your wireless microphone units back to the base unit
charging cradles for charging.
This display shows
NO LINE. I cannot hear the
dial tone.
Disconnect the telephone line cord from your telephone
and connect it to another telephone. If there is no dial tone
on that other telephone either, then the telephone line cord
may be defective. Try installing a new telephone lind cord.
If changing telephone line cord does not help, the wall jack
(or the wiring to this wall jack) may be defective. Contact
your telephone service provider.
You may be using a new cable or VoIP service, the existing
telephone jacks in your home may no longer work. Contact
your service provider for solutions.
Wireless microphone unit
doesn’t work
Make sure all cables of the base unit are plugged in correctly.
Make sure the base unit is not placed near other DECT
phones or electronic devices that could cause interference.
Make sure your wireless microphone unit is not moved out
of range – try moving it closer.
Put back your wireless microphone unit on the base unit
charging cradles for 8 hours. If it still doesn’t work, the
battery may be flat, dead, or incorrectly inserted. Recharge
or replace the battery, and then follow the procedures below
to do registration again:
1. When the base unit is in idle, put all wireless microphone
units onto the base unit charging cradles.
2. Enter the registration code *331734# quickly, and then
press OK twice at base unit.
3. If registration is successful, the display will show
REGISTRATION DONE”.
Try resetting the base unit. Unplug its power and wait for
15 seconds. Then, plug it back in, and give it a minute to reset.
There’s a red light
flashing on my wireless
microphone unit.
Put the wireless microphone unit on the base unit so it can
charge. If this doesn’t work, replace the battery.
The base unit doesn’t ring The ringer volume may be switched off.
Make sure all cables of the base unit are plugged in correctly.
Make sure the base unit is not placed near other DECT
phones or electronic devices that could cause interference.
Try resetting the base unit. Unplug its power and wait for
15 seconds. Then, plug it back in, and give it a minute to reset.
8. TROUBLESHOOTING
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Alcatel CONFERENCE 1500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Alcatel CONFERENCE 1500

Alcatel CONFERENCE 1500 Bedienungsanleitung - Deutsch - 31 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info