541385
5
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
iDR MixRack Getting Started Guide 5 AP7445 iss.3
Front Panel
Mic/Line inputs High performance, recallable
analogue preamps for balanced or unbalanced
microphone and line level signals. Gain, Pad
and 48V are digitally controlled within the
preamp. Digital Trim and Polarity is available
within the DSP channel.
Inputs are identified by Slot (card position) and
Socket (number), for example A1 or C8. Any
input can be patched to any DSP channel
using the PREAMP screen.
Line outputs Line level, balanced XLR
outputs. Nominal level +4dBu with +22dBu
maximum providing +18dB headroom.
iLive signals can be patched to any output
socket using the OUTPUTS screen. The
outputs are relay protected to prevent power
on or off thumps.
PL-Anet RS485 connection for Allen & Heath
PL Series remote controllers. Several may be
daisy chained together or routed individually
via the PL-9 PL-Anet hub. PL controls can be
assigned using the SURFACE SETUP screen
or Editor software.
MIDI IN and OUT sockets.
MIDI is tunnelled via ACE™
or Network to the MIDI port
at the Surface. For more
information about MIDI
refer to the iLive MIDI
Specification.
Network Built-in 3 port switch. Connect one or more laptops
running iLive Editor, a wireless router, other iLive systems or
external network, or link control to a Surface not equipped
with ACE™. All devices on the network must have
compatible TCP/IP addresses. A recessed switch lets you
reset the network settings to factory default.
ACE™ MixRack to Surface link Also used when linking a
Slave MixRack to a Master in Dual-Rack expansion mode. A
single CAT5 cable links audio and control. You do not need
a separate Network cable because control is bridged over
the ACE™ cable between MixRack and Surface.
PHONES ¼” stereo socket and level control
for the built-in headphone amplifier. The
output follows the PAFL selection.
Port B audio network option slot Fit one of
the option cards available for system
expansion, digital mic splitting and distributed
audio networking. Capable of bi-directional 64
channels, 48kHz sampling rate. Current
options include ACE™, EtherSound, MADI,
MMO. Refer to the A&H web site for more on
available options.
SYSTEM LOC
K
indicates MixRack digital audio
sync lock.
Rack Ears Fit into a 19”
rack or flightcase.
PL-9 hub
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Allen-Heath iDR-48 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info