644612
4
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
4
User’s manual
EN
skills, please disconnect power and activate the safety device. However, the user must take all necessary safety precautions,
in particular when working on the bottom of the lawnmower robot, following procedures indicated by the manufacturer.
•
Use the personal protection devices recommended by the Manufacturer, in particular, always wear protective gloves when
handling the cutting blade.
•
Before replacing the batteries, always remove the blade.
•
Make sure the air vents of the power supply unit are free and clear of residuals.
•
To avoid irreversible damage to the electric and electronic parts, do not wash the robot with water jets at a high pressure and
do not immerse it in water, partially or completely, as it is not watertight.
•
Operators who perform repairs during the working life of the robot must have the necessary technical expertise, skills and
experience in this specic eld. The lack of these requirements may be hazardous to the health and safety of people.
•
Inspect the robot at regular intervals to ensure that the blade, the assembly screws and the cutting mechanism are not worn
or damaged. Replace badly worn parts using original spare parts to ensure proper function and the required safety level.
•
Make sure that all nuts, bolts and screws are tightened to ensure that the robot is in good operating conditions.
•
The robot cannot be used without the top cover. If the mechanical parts of the robot are damaged, replace them.
•
Any routine or extraordinary maintenance (e.g. battery replacement) must be performed by an authorised service centre.
•
The Manufacturer shall not be held liable if non-original spare parts are used.
•
Never use and recharge the robot in explosive and/or ammable environments.
•
To recharge the robot, use only battery chargers and power supply units provided by the supplier. Improper use may cause
electric shocks, overheating or leakage of corrosive liquids from the battery. If any liquid leaks, the battery must be washed
with water / neutraliser; seek medical assistance for contact with the eyes.
SAFETY DEVICES
1. Bumpers
The bumper sensor is activated if the robot strikes a solid object greater than 9 cm (3.54 ") in height, which stops the movement
in that direction and moves backwards to avoid the obstacle.
2. Inclinometer
If the robot works on a slope which is steeper than the maximum limit, or tips over, the robot will stop the cutting blade.
3. Emergency stop switch
Located on the control panel with the word “STOP” larger than the other commands on the keypad. Pressing this button at any
time during operation will immediately stop the movement of the lawnmower robot and the rotation of the blade will stop within
2 seconds.
4. Over-current protection
Each motor (blade and wheels) is monitored continuously during operation for any situation that may cause them to overheat. If
this occurs in the wheel motor, the robot will attempt to move in the opposite direction. If the over-current persists, the robot will
stop and signal an error. If the cutting blade motor overheats, there are two intervention ranges. If the parameters fall within the
rst range, the robot will perform the manoeuvres to unblock the cutting blade. If the over-current is below the protection range,
the robot will stop and signal a motor error.
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ambrogio L50 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Ambrogio L50

Ambrogio L50 Bedienungsanleitung - Deutsch - 23 seiten

Ambrogio L50 Bedienungsanleitung - Deutsch - 18 seiten

Ambrogio L50 Zusatzinformation - Holländisch - 3 seiten

Ambrogio L50 Zusatzinformation - Holländisch - 2 seiten

Ambrogio L50 Bedienungsanleitung - Holländisch - 44 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info