Bedienungsanleitung Amica EGSP 24098 E - Premiere (Seite 26 von 29) (Englisch)

751253

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

The following things should be checked before starting the dishwasher.

The content of this manual is very helpful to the users.

After installation, please make sure to keep this manual.

The dishwasher is level and fixed properly

The inlet valve is open

There is not a leakage at the connections of the conducts

The wires are tightly connected

The power is switched on

The inlet and drain hoses are not knotted

All packing materials and printings should be taken out from the dishwasher

Syphon Connection

Extension Hose

If you needa drainhose extension, make sure to use a similar drain hose.

It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.

Water Outlet

Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.

Ensure that the water drain hose is not kinked or squashed.

Positioning the Appliance

If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly

into the sink. It will be necessary todrain excesswater from hoses into a bowl or suitable

container that is held outside and lower than the sink.

Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,

along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can

be positioned either to the right or the left sides to facilitate proper installation.

How to Drain Excess Water From Hoses

The waste connection must be at a height of between 40 cm (minimum) and 100 cm (maximum)

from the bottom of the dish. The water drain hose should be fixed by a hose clip. The free end of

the hose must not be immersed in water.

Please close the hydrant after using.

Turn off the water.

Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and

the room, from severe splashing.

Unscrew The safety supply hose from the faucet..

Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.

If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the

water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and

damage the appliance.

A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it

is recommended thet the hose be disconnected and the hole plugged.

The safety supply hose consists of the double walls. The hose's system guarantees its intervention by blocking the flow of water

in case of the supply hose breaking and when the air space between the supply hose itself and the outer corrugated hose is full

of water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Amica EGSP 24098 E - Premiere Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Amica EGSP 24098 E - Premiere

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info