Bedienungsanleitung Angelcare AC117 (Seite 3 von 64) (Englisch, Französisch, Spanisch)

681982

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

IMPORTANT SAFETY

INSTRUCTIONS

30. is monitor uses public airwaves to transmit signals. e Parent Unit may

pick up signals or interference from other nursery monitors in your area. Your

monitor may even be picked up by other households. To protect your privacy, make

sure both units are turned OFF when not in use. If you experience interference,

change the channel on both units

31. Power cord protection - Protect the Adapter’s power cord from being

walked on or pinched by furniture or other items – Power supply cords

should be routed so that they are not likely to be walked on or pinched by items

upon or against them, paying particular attention to cords and plugs, convenience

receptacle, and the point where they exit from the product. e socket outlet

shall be installed near the equipment and shall be easily accessible. Make sure

to plug the adapter to the socket outlet nearest to the equipment and that is

easily accessible. To disconnect from mains, unplug the adapter.

32. Only use attachments/accessories and replacement parts speciﬁed

by the manufacturer. Any mounting of the product should follow the

manufacturer’s instructions.

• DO NOT position this product on an unstable cart, stand, tripod, bracket

or table. e product may fall, causing serious injury to a child or adult and

serious damage to the product.

• Use ONLY with a cart, stand, tripod, bracket or table recommended by the

manufacturer or sold with the product.

• Be sure replacement parts are supplied by Angelcare and have the same

characteristics as original part. Unauthorised substitution may result in ﬁre,

electric shock or ﬁre.

33. Unplug this appliance during lightning storms or when not used

for long periods of time

34. Servicing - DO NOT attempt to service this product yourself as

opening or removing covers (except battery door) may expose you to

dangerous voltage or other hazards.

35. Power Supply – see Technical Speciﬁcation within this guide.

36. Overloading - DO NOT overload wall outlets, extension cords or

integral convenience receptacles as this can result in a risk of ﬁre or

electric shock.

37. Nursery Unit Antenna - e antenna used for this transmitter must be

installed to provide a separation distance of at least 8’’ (20 cm) from all persons

and must not be collocated or operating in conjunction with any other antenna

or transmitter.

38. Cleaning - Disconnect all units before cleaning. DO NOT immerse in water

any part of the monitor. Clean only with dry cloth.

39. Sensor Pad –

• Vibration Source/interference - When the Sensor Pad is in use, DO

NOT use a crib mobile, other crib accessories that may produce vibrations.

Other sources of vibrations may include fans, washing machines, loud music,

etc. ese sources of vibration may interfere with the performance of your

Angelcare® monitor and the alarm will not sound if it continues to detect any

movement other than your baby’s. Be sure all vibration sources are eliminated

before using the monitor.

• Sensor Pad can only be used in any crib that is stationary on a completely

ﬂat, ﬁrm surface. If the crib has a spring or slat base, place a hard board

between the crib base and the Sensor Pad measuring at least 33 x 33 cm (13”

x 13”) and 6 mm (1/4”) thick. Box this safety instruction or move to instruction

section for setting up sensor pad or repeat

• e sensor pad is made of plastic and does not permit the air to

circulate. erefore, mildew build up could develop underneath the mattress

in the sensor pad area. We suggest rotating the mattress regularly to prevent

any mildew.

40. False alarms may happen for several reasons:

• Nursery Unit has not been turned OFF after you have removed your baby

from the crib.

• Sensor Pad has not been placed under the mattress properly. Be sure the

Sensor Pad is on a ﬂat, ﬁrm surface with the printed side facing up.

• e sensitivity level may also need to be adjusted. Refer to User’s Guide.

Always be sure to immediately check on baby whenever an alarm sounds.

WARNINGS

41. Modiﬁcations not authorized by the manufacturer may void users authority

to operate this device.

41.1 NOTE: is equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules. ese limits

are designed to provide reasonable protection against harmful interference

in a residential installation. is equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

41.2 However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment

OFF and ON, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a circuit

diﬀerent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

41.3 is device complies with the part 15 of the FCC Rules and the Industry

Canada license - exempt RSS standards(s). Operation is subject to the

following two conditions:

(1) is device may not cause harmful interference, and

(2) is device must accept any interference received, including interference

that may cause undesired operation.

IC Warning :

42. is device complies with industry Canada RSS standard(s). Operation is

subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including inferences that may

cause undesired operation of the device.

42.1 Changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

FCC AND IC REGULATIONS

RF radiation exposure statement

e Nursery Unit complies with FCC RF radiation exposure limits set

forth for an uncontrolled environment.

Caution: To maintain the compliance with the FCC’s and Industry

Canada’s RF exposure guideline, install the Nursery Unit at least 7.9”

(20 cm) from ALL persons. e transmitter of this device must not

be co-located or operating in conjunction with any other antenna

or transmitter.

Industry Canada

is product meets the applicable Industry Canada technical

speciﬁcations.

CAN ICES-3 (B)/NMB-3 (B)

241AC_Manuel_AC117_NA_m3.indd 3 18-03-02 09:20

Angelcare AC117 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info