Bedienungsanleitung Angelcare AC201-2P (Seite 6 von 56) (Englisch, Französisch, Spanisch)

681983

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

20) Antenna -The antenna used for this transmitter

must be installed to provide a separation distance of

at least 20 cm (7.9”) from all persons and must not

be collocated or operating in conjunction with any

other antenna or transmitter.

21) Power Lines- An outside antenna system should

NOT be located in the vicinity of overhead power

lines or other electric light or power circuit, or where

it can fall into such power lines or circuits as contact

with them may be fatal.

22) STRANGULATION HAZARD. Children have

STRANGLED in cords. Keep the adapter cords and

sensor pad cord out of the reach of children.

Because of the serious strangulation risk to infants

and toddlers, parents and caregivers should NEVER

place the nursery unit within 3 feet (1 meter) of a crib.

NEVER use extension cords with AC adapters.

ONLY use the AC adapters provided.

23) Interference- This monitor uses public airwaves

to transmit signals. The Parent Unit may pick up

signals or interference from other nursery monitors in

your area. Your monitor may even be picked up by

other households. To protect your privacy, make sure

both units are turned off when not in use. If you expe-

rience interference, change the channel on both

units.

24) Vibration Source- When the monitor is in use, do

NOT use a crib mobile or other crib accessories that

may produce vibrations. Other sources of vibrations

may include fans, washing machines, loud music,

etc. These sources of vibration may interfere with the

performance of your Angelcare® monitor and the

alarm will not sound if it continues to detect any

movement other than your baby’s. Be sure all vibra-

tion sources are eliminated before using the monitor.

You may experience false alarms for several rea-

sons. The most common reason is the Nursery Unit

has not been turned off after you have removed your

baby from the crib. Another reason is the Sensor Pad

has not been placed under the mattress properly.

Be sure the Sensor Pad is on a flat, firm surface with

the printed side facing up. The sensitivity level may

also need to be adjusted. Refer to the Movement

Sensitivity Adjustment section. Always be sure to

immediately check on baby whenever an alarm

sounds.

25) Sensor Pad- Your sensor pad can be used in any

crib that is stationary and designed to safely hold a

baby. If the crib has a spring or slat base, place a

hard board between the crib base and the Sensor

Pad measuring at least 13” x 13” (33 x 33 cm) and

1/4 inch (6 mm) thick. Only use your Angelcare®

monitor in a stationary sleeping environment such as

a crib where the Sensor Pad can rest on a complete-

ly flat, firm surface.

ALWAYS route the sensor pad cord below crib mat-

tress ONLY and out of reach of children.

IMPORTANT SAFETY INSTRUCTIONS

RELATED TO USE OF BATTERIES

1) Use ONLY the type and size of batteries specified

in the user manual. There is a risk of explosion if bat-

teries are replaced with an incorrect type.

2) ONLY use the AC adapters included with your

monitor.

3) Do NOT use these adapters with any other equip-

ments.

4) When unplugging the AC adapter from the nursery

unit, be sure it is switched to the off position. If it isn’t,

the unit will revert to battery mode if batteries are

installed.

5) Do NOT dispose batteries in fire. They may

explode. Check with local regulations for possible

special disposal instructions.

6) Exercise care in handling batteries in order not to

short out the batteries with conducting materials

such as rings, bracelets and keys. Overcharging,

short circuiting, reverse charging, mutilation, or incin-

eration of batteries must be avoided to prevent one

or more of the following occurrences: release of toxic

materials, release of hydrogen and/or oxygen gas,

rise in surface temperature.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Angelcare AC201-2P Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info