665512
6
Zoom out
Zoom in
Vorherige Seite
1/7
Nächste Seite
13
V 06/16
CONTROL PANEL
Move the switch-on button (on the rear, beneath the air intake grille) to position ‘I’. When the appliance emits a beep, this
means that the fan heater is ready for use (stand-by). The
STAND-BY LED is lit.
By pressing the STAND-BY button ‘ ’, the appliance will start functioning in NORMAL mode, at the
COMFORT heat level
.
At this stage it is possible to leave the NORMAL operating mode or select the BODY-SENSOR mode (activation
of the PRESENCE SENSOR): the corresponding LED will light up.
In both the NORMAL and in the BODY-SENSOR modes, it is possible to select the COMFORT mode
(maximum heat 2000 W) or the ECO mode
(minimum heat 1300 W) or cool ventilation (seq.). It is also
possible to set the timer for switch-off, after 1, 2 or 4 hours.
When the COMFORT mode is selected, the appliance will first operate for 10” at minimum power before
activating the maximum heat mode.
If the unit is operating and the
STAND-BY button is pressed, the unit will continue to ventilate for a few minutes
before switching off completely, to cool the ceramic heating element.
If the unit has been in stand-by mode for quite some time, so that the heating element has already cooled
down, pressing the ON/OFF button causes the unit to switch off instantly, without ventilating.
In the BODY-SENSOR mode: every 2 minutes the unit detects the presence of people in the room, in the range
of approximately 2 metres. If is does not detect anyone and the ECO or COMFORT modes have been selected,
the heating element switches off but the fan will continue operating for 8 minutes: the unit will then enter the
stand-by mode. If the cold ventilation mode is selected, the fan will continue to operate for 10 minutes before
entering the stand-by mode.
To switch off the fan heater completely, move the on/off button to the “0” position.
STAND-BY
LED
OPERATING
MODE LED
1. STAND-BY BUTTON
2. SELECTION BUTTON
operation without PRESENCE
SENSOR (NORMAL) or with
PRESENCE SENSOR (BODY-S)
3. OPERATING MODE BUTTON
COMFORT – maximum heat (2000 W)
ECO – minimum heat (1300 W)
ventilation only
(repetition sequence)
4. TIMER BUTTON:
with the unit operating it
allows for programming the
switch-off after 1, 2 or 4
hours, by pressing it once,
twice or three times
(repetition sequence)
NORMAL or
BODY-SENSOR
MODE LED
TIMER LED
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Argo Dream wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Argo Dream

Argo Dream Bedienungsanleitung - Deutsch - 8 seiten

Argo Dream Bedienungsanleitung - Französisch - 8 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info