665463
26
Zoom out
Zoom in
Vorherige Seite
1/30
Nächste Seite
V 11/15
56
Refrigerating connections
Use equipment and connecting pipes
suitable for R410A refrigerator.
Meters
Pipes length with a standard
refrigerating charge
5
Maximum pipes length with
additional charge
20
Maximum pipes length per unit 10
Additional charge g/m 15
Always write the additional
refrigerant charge on the data label
affixed to the unit outside.
The maximum height difference
between indoor and outdoor unit is
10m.
Wrap with straps all refrigerant pipes
and joints.
Tighten connections using two keys
operated in opposite directions.
Keep sealed all open extremities of the
pipes with a cap until the connection is
completed. Be sure not to let anything in
the pipes or in the system, such as dirt,
water, etc.
The piping connected to the indoor and
outdoor unit must be new. Required
thickness of pipes is 0.8 mm or more.
Only use R410A refrigerant in line woith
the one already loaded in the outdoor unit
to fill the refrigerant in the system.
Additional charge of refrigerant and oil
If the length of the connecting pipe is
increased by 10 m compared to the
standard length, add 5 ml of refrigerant
oil for every 5 m of pipe added.
Method for calculating the amount of
additional refrigerant charge (liquid pipe):
amount of additional refrigerant charge =
additional length of pipe liquid x amount
of additional refrigerant charge per meter.
Vacuum pump
Using the vacuum pump
Remove the valve caps of the liquid valve and
gas valve and remove the nut of the
refrigerant charge port.
Connect the piezometer charge pipe to the
refrigerant charge bore of the gas valve. Then
connect the other charge pipe to the vacuum
pump.
Open the piezometer completely and let it run
for 10 – 15 minutes to check if the pressure of
the piezometer remains at -0.1 MPa.
Close the vacuum pump and maintain this
condition for 1 – 2 minutes to check if the
pressure of the piezometer remains at -
0.1 MPa. If the pressure falls, there may be a
leak.
valvola del liquido
valvola del gas
apertura carica
refrigerante
dado apertura
carica refrigerante
pompa a vuoto
piezometro
cappuccio
valvola
Lo Hi
chiave esagonale
interna
aprire
chiudere
valvola del liquido liquid valve
valvola del gas gas valve
aperturacaricarefrigerante refrigerant charge port
dado aperturacaricarefrigerante refrigerant charge port
piezometro piezometer
cappucciovalvola valve cap
pompa a vuoto vacuum pump
chiaveesagonaleinterna inner hex key
chiudere close
aprire open
Remove the piezometer. Fully open the plunger of the liquid valve and gas valve with the inner
hex key.
Tighten the screw caps of the valves and refrigerant charge port.
Reinstall the handle.
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Argo Wall Dual 9000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Argo Wall Dual 9000

Argo Wall Dual 9000 Bedienungsanleitung - Deutsch - 34 seiten

Argo Wall Dual 9000 Bedienungsanleitung - Französisch - 32 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info