Bedienungsanleitung Ariston A1636 (Seite 13 von 16) (Englisch)

47609

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Troubleshooting

Problem:

The washing machine won’t

start?

The wash cycle won’t start?

The washing machine fails

to fill with water?

The washing machine

continuously fills with water

and drains?

The washing machine does

not drain or spin?

The washing machine

vibrates too much during the

spin cycle?

The washing machine leaks?

The ON-OFF/DOOR LOCKED

LED flashes rapidly at the

same time as at least one

other LED?

There is too much foam?

Possible causes / Solution:

● The appliance is not fully plugged into the socket.

● There has been a power failure.

● The appliance door is not shut properly.

● The button has not been pressed, for at least 2 seconds.

● The START/RESET button has not been pressed, for at least 2

seconds.

● The water tap is not turned on.

● A delayed start has been set (using the Delay Timer, see page 7).

● The water inlet hose is not connected to the tap.

● The hose is kinked.

● The water tap is not turned on.

● There is a water shortage.

● The water pressure is insufficient.

● The START/RESET button has not been pressed, for at least 2

seconds.

● The drain hose is not fitted between 65 and 100cm from the floor (see

page 3).

● The free end of the hose is underwater (see page 3).

● The wall drainage system doesn’t have a breather pipe.

If the problem persists even after these checks, turn off the water tap,

switch the appliance off and call for assistance. If the dwelling is on one

of the upper floors of a building, there may be drain trap problems

causing the washing machine to load and unload water continuously. In

order to avoid such an inconvenience, special anti-drain trap valves are

available in shops.

● If the machine was unable to balance the load it will use a slow spin

rather than risk machine damage; the clothes might appear wetter

than expected.

● The Easy Iron option is enabled: to complete the programme, press

the START/RESET button (see page 7).

● The drain hose is bent (see page 3).

● The drain duct is clogged.

● The transit bolts were not removed correctly (see page 2).

● The washing machine is not level (see page 2).

● The washing machine is closed in, between furniture cabinets and the

wall (see page 2).

● The water inlet hose is not screwed on correctly (see page 2).

● The detergent dispenser is obstructed (to clean it, see page 10).

● The drain hose is not secured properly (see page 3).

● Call for assistance because this means there is an error.

● The detergent is not suitable for machine washing (it should bear the

definition “for washing machines” or “hand and machine wash”, etc.)

● You used too much detergent.

Your washing machine could fail to work. Before calling for assistance (see page 12),

make sure the problem can’t easily be solved by consulting the following list:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston A1636 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info