Bedienungsanleitung Audio-Technica AT-LP5X (Seite 15 von 16) (Englisch)

704632

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Troubleshooting

Problem Solution

The platter does not spin. • Is the AC adapter connected to the outlet? Connect AC adapter to the outlet.

• Has the AC adapter's plug come off? Check whether or not the plug is properly attached to the AC adapter.

The platter spins, but there is

no sound or the volume is not

loud enough.

• Is the cartridge's protector still in place? Remove the cartridge's protector.

• Is the tonearm in the lift position? Lower the tonearm.

• Are the function settings and input for connected equipment (amplifier, etc.) selected correctly? Check

whether the settings for the connected equipment are correct.

• Is the stylus damaged? Check the stylus and replace it, if necessary.

• Is the stylus placed correctly on the body of the cartridge? Check the cartridge and adjust it, if necessary.

• Are the setting positions for the pre-amplifier selector switch correct? Check that the pre-amplifier settings

are correct, noting the following common problems and their causes:

- If there is no sound, or if the volume is not loud enough, the product is set to the “PHONO” position

and connected to the amplifier’s AUX/LINE input.

- If the volume is too loud or is distorted, the product is set to the “LINE” position and connected to the

amplifier's PHONO input.

• If using an MC cartridge and setting the MM (VM)/MC cartridge selector switch to the MM position, the

volume becomes low. Set the switch to the MC position.

• Is the tracking force set too heavy? Adjust the tracking force.

The stylus skips. • Is the tracking force set too light or too heavy? Adjust the tracking force.

• Is the anti-skate set improperly? Verify anti-skate is set for same value as cartridge tracking force.

• Is the record warped? Check the record.

• Is the record scratched? Check the record.

There is howling. • Is the product picking up excessive vibrations from the floor, surfaces of the walls, or nearby speakers?

Decrease the vibrations or mount the product on a surface that is not subject to the effects of vibrations.

• Is the product mounted on an unstable surface? Check whether the surface on which the product is

mounted is suitable.

There is noise when the record

is playing.

• Is there dust on the cartridge’s stylus tip? If dust is stuck to the stylus tip, clean it with a commercially

sold brush.

The sound when the record is

playing is either too fast or too

slow.

• Are the speed settings for the product correct? Use the control knob to select the correct speed for the

type of record being played.

Humming is heard during

playback.

• Is the ground line connected correctly? Make sure the ground line is properly connected.

• Is the headshell attached to the tonearm firmly? Make sure the locking ring is tight.

Dimensions

(Unit: mm)

157.0

450.0

352.0

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Audio-Technica AT-LP5X Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Audio-Technica AT-LP5X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info