Bedienungsanleitung Audiophony TT-2930 (Seite 7 von 8) (Englisch)

603152

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Page 7

TT-2930 - High-torque Professinal turntable system English

6 - Operating

1 - Turn the power dial to turn on and the speed indicator

and the strobe-illuminator will light up.

2 - Turn on and raise the target light for illumination the

stylus tip by pushing the target light button.

3 - Place a record on the turntable mat. When playing a

45rpm record with a large center hole; place the 45-rpm

adapter on the center spindle.

4 - Set the rotation speed (33/45/78) to match the record.

5 - Release the arm clamp.

6 - Set the cueing lever to the up position.

7 - Press the Start/Stop button and the turntable platter

will start to rotate.

8 - Move the tone arm over the desired groove.

9 - Set the cueing lever to the down position, the tone arm

will descend slowly onto. The record and play begins.

10 - Set the desired pitch adjusts range by depressing

the Quartz buttons until the desired pitch is reached.

Options are +/-10% or +/-20%

11 - Adjust the pitch to a desirable speed. During play,

observe the strobe dots. If the strobe dots appear to the

right, the pitch is slower than the rated speed. If they flow

to the left, the pitch is faster than the rated speed.

If the strobe dots appear stationary, which means the

platter is in normal turntable speed, move the pitch

control slider up or down to adjust the speed.

12 - To suspend play, lift tone arm with cueing lever.

13 - When play is finished, raise the cueing lever, move

the tone arm to the armrest and secure the tone arm with

the arm clamp.

14 - Turn the target light off by pushing the light back

down.

15 - Press the Start/Stop button to stop the platter

rotating.

16 - Turn the power dial to turn off the power.

1 - Remove the main unit with the packing from the box

and take off the packing.

2 - Set the 45rpm adaptor on the main unit.

3 - Insert the turntable platter onto the centre spindle.

4 - Set the slip mat on the platter.

5 - Installation of cartridge:

When installing a cartridge, refer to the operating

instructions of that cartridge. During installation, attach

the stylus protector to guard the stylus tip from damage.

(a) Connect the lead wires to the cartridge terminals. The

terminals of cartridge are colour coded.

Connect each lead wire to the terminal of the same

colour.

White (L+) Left channel +

Blue (L -) Left channel –

Red (R+) Right channel +

Green (R-) Right channel –

(b) Install the cartridge to the headshell and tighten it

with screws provided with the cartridge.

6 - Insert the headshell into the front end of the tonearm,

then turn the lock nut clockwise with the headshell firmly

held horizontally.

7 - Slide counterweight onto tonearm.

Twist it lightly and it will screw onto the rear shaft of the

tonearm.

5 - Assembly

8 - Adjustment of horizontal zero (0) balance and stylus

pressure:

(a) Remove the stylus protector, do not touch the stylus

tip during the adjustment.

(b) Set the cueing lever to the lower position.

arm rest to free it.

(d) Rotate the counterweight until the tonearm is

approximately balanced horizontally (floats freely).

(e) Refasten the tonearm with the arm clamp.

(f) Hold the counterweight stationary with one hand and

rotate only the stylus-pressure ring to bring the number

"0" of the ring into alignment with the centre line on the

tonearm rear shaft.

(g) Rotate the counterweight clockwise until the scale

shows the value corresponding to the pressure of the

used stylus. The stylus pressure of the installed pick-up

system is 2 g. If you use a separate pick-up system,

please follow the manufacturer’s instructions.

9 - Set the anti-skating control knob to the same value as

the stylus pressure.

10 - Install the dust cover to the main unit

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Audiophony TT-2930 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info