658720
14
Zoom out
Zoom in
Vorherige Seite
1/17
Nächste Seite
ULTRASONIC SPEED SENSOR
13
1.9.3 Attaching the safety wire
Plastic housing – Attach the wire to one eye of the hull nut. Twist the wire in a
anti-clockwise direction and thread it through one of the eyes in the cap nut,
then through the pull ring and the other eye of the cap nut, and finally through
the opposite eye of the hull nut. Twist the wire onto itself to lock the assembly.
Bronze housing – Wrap one end of the locking wire around the housing and
twist it together. Thread the other end up through the eyehole in the cap nut,
loop the wire through the pull ring and twist it securely onto itself to lock the
assembly.
Route the cables to the interface box being careful not to damage the insulation
when passing through bulkheads etc. In order to reduce electrical interference,
separate the sensor cables from electrical wiring and other sources of noise.
Immediately after putting the boat into the water, check the installation for signs
of leakage. Note that small leaks may not be readily observed. It is advised that
the boat is not left in the water for more than 3 hours before re-checking the
installation for leaks.
If leakage is observed, remove the boat from the water and repeat the
installation procedure.
Figure 1.7 - Preparation of a Cored Fibreglass Hull
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für BandG Ultrasonic Speed Sensor wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info