Bedienungsanleitung Bauknecht GTE 275 (Seite 4 von 8) (Englisch)

591812

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

APPLIANCE DEFROSTING

The appliance should be defrosted when the thickness

of ice on the walls reaches 5-6 mm.

• Disconnect the appliance from the power supply.

• Remove food from the appliance and put it in a very

cool place or a thermally insulated bag.

• Leave the appliance door open.

• Remove the internal defrost water drain plug

(depending on model) (Fig. 8).

• Remove the external defrost water drain plug

(depending on model) and reposition it as shown in

g. 8.

• Use the separator (depending on model) inside the

product as a recipient for any remaining water, (D) as

shown in g. 8. If there is no separator, use a shallow

container.

• Defrosting can be sped up by using a spatula to

detach the frost from the appliance walls.

• Remove the frost from the bottom of the appliance.

• In order to avoid permanent damage to the

appliance interior, do not use pointed or sharp

metal instruments to remove the ice.

• Do not use abrasive products or heat up the

interior articially.

• Dry the inside of the appliance thoroughly.

• Ret the plug after defrosting.

CLEANING AND MAINTENANCE

• Remove the frost from the upper edges (see

Troubleshooting Guide).

• Clean the inside after defrosting, using a sponge

dampened with warm water and/or mild detergent.

• Clean the side vent (if provided).

Unplug the appliance before carrying out

maintenance operations. Do not use abrasive

products, scourers or stain-removers (e.g. acetone,

trichloroethylene) to clean the appliance.

To obtain the best results from your appliance, carry

out cleaning and maintenance at least once a year.

CHANGING THE LID LIGHT BULB (if provided)

• Disconnect the appliance from the mains power

supply.

• Remove the diuser by following the sequence of

steps shown in the gure.

• Unscrew the light bulb and replace it with an identical

bulb of the same wattage and voltage.

• Ret the diuser and plug in the appliance.

TROUBLESHOOTING GUIDE

1. The red indicator light ashes.

• Is there a power failure?

• Has defrosting been carried out?

• Is the appliance lid properly closed?

• Is the appliance positioned near a heat source?

• Are the ventilation grille and condenser clean?

2. All the led indicators ash at the same time.

• Contact After-sales Assistance.

3. The appliance is too noisy.

• Is the appliance perfectly horizontal?

• Is the appliance in contact with other furniture of

objects that may cause vibrations?

• Has the packaging been removed from under the

appliance?

Note: Slight gurgling noises from the refrigerating

circuit after the compressor cuts out are perfectly

normal.

4. The indicator lights are o and the product is not

working.

• Is there a power failure?

• Is the plug properly inserted in the socket?

• Is the electrical cable intact?

5. The indicator lights are o and the product is

working.

• Contact the After-sales Service.

6. The compressor runs continuously.

• Have hot foods been put in the appliance?

• Has the lid of the appliance been left open for a

long time?

• Is the appliance positioned in a very warm room or

near heat sources?

• Has someone activated the “Shopping” function?

(green indicator lamps (3) ashing) and/or the

Turbo Freeze function (yellow indicator lamp on)?

7. Too much ice forms on the upper edges.

• Are the defrost water drainage plugs correctly

positioned?

• Is the appliance lid properly closed?

• Is the appliance lid seal damaged or deformed?

(See section “Installation”)

• Have the 4 protection pieces been removed? (See

section “Installation”)

8. Condensation forms on the external walls of the

appliance.

• It is normal for condensation to form under certain

atmospheric conditions (humidity above 85%)

or if the appliance is located in a damp or poorly

ventilated room. However, this in no way aects

appliance performance.

9. The layer of ice on the internal walls of the

appliance is not uniform.

• This is perfectly normal.

SAFEGUARDING THE ENVIRONMENT

1. Packing

The packing material is 100% recyclable and bears the

recycling symbol. For disposal, comply with the local

regulations. Keep the packing materials (plastic bags,

polystyrene parts, etc.) out of the reach of children, as

they are a potential source of danger.

2. Scrapping/Disposal

The appliance is manufactured using recyclable material.

This appliance is marked in compliance with European

Directive 2002/96/EC on Waste Electrical and Electronic

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht GTE 275 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht GTE 275

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info