5019 401 05431
Add detergent as indicated on the front page and as
described in the chapter “Detergent and Additives” in
your Instructions for Use.
Turn the programme selector to the desired programme.
The
temperature
and
spin speed
indicated on the
display can be altered by pressing the “Temperature”
button or the “Variable
When the combination of programme and additional
option(s) is not possible, the indication lights switch off
automatically. Unsuitable combinations of option
deselected automatically.
“Prewash” button
• Only for heavil
granular dirt) sensible.
approximately 15 min.
• Do not use liquid detergent for the main wash when
activating the Prewash option.
“Rinse hold” button
• The laundry remains in the last rinse water without
progressing to the final spin cycl
prevent colours from changing.
• T
programmes “Synthetics”, “Daily load” and “Delicates”.
• It is particularly useful if you want to postpone spinning
to a later time, or if you wan
• If you select “Rinse hold”, do not leave the laundry to
soak for too long.
Note:
The programme stops to “Rinse hold” at the
time the “Rinse hold” symbol on the display lights up.
The light over the
“Start”
button flashes.
T
• Press the
“Start”
button; the programme will
terminate automatically
present wash programme.
• If you do not wish
“Reset”
button
and then the
“Start”
button to start
the Drain programme.
“
• Every p
• Press the button to set another spin speed.
• If spin speed “0” is selected, the final spinning is
cancelled but intermediate spin peaks remain during
rinse. The water is drained out only
“Intensive rinse” button
• More water is added and rinse cycle is prolonged.
• This opti
soft water or for washing baby linen, and helps people
with allergies.
“Eco” button
• With a modified temperature profile and a slightly
prolonged washing duration, the optimum
combination of excell
lower energy consumption is achieved.
“Steam Hygiene +” button
• Eliminates bacteria and helps sanitizing the laundry
• A
care label within temperature range of 40 to 60°C.
CONSUMPTION DATA
Programme
T
(°C)
Load
(kg)
Wa
(l)
Energy
(kWh)
Approx. Programme Duration
(hours : minutes)
*
White Cotton / Hygiene + 95 7.0 70
**
2.10 2:10
Coloured Cotton 60 7.0 65 1.33 2:10
Coloured Cotton with “Eco”
***
60 7.0 6 1.19 2:20
Coloured Cotton 40 7.0 65 0.75 2:05
SuperEco 60 7.0 62 0.84 4:00
Synthetics 60 3.5 48
**
0.95 1:35
Synthetics 40 3.5 4 0.55 1:20
Daily load 40 5.0 6 0.60 1:00
Quick wash 30 5.0 6 0.30 0:30
Steam Refresh — 1.0 1 0.20 0:10
Steam Auto Clean — — 11 0.50 0:35
Delicates 30 2.5 6 0.45 0:50
W 40 2.0 6 0.65 0:45
Handwash 40 2.0 4 0.65 0:40
Consumption values were measured in normalized conditions in compliance with Stane
may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type o
*
The time indicated on the display can deviate from the vaons
applicable at that time.
**
Tut.
***
Reference P
ADD DETERGENTS, CLOSE THE DOOR
AND SELECT THE PROGRAMME
SELECT ANY DESIRED OPTIO
• P
hour
• I
the steam phase.
“Steam P
• T
cycle in order to
• Selectable for laundry made of cotton and/or
synthetics within temperature rang
• If you select
during the steam phase.
The “Start delay” allows to run the machine at the
consumer’s convenience, for example at night when
electricity is
activating the “Start delay”.
• S
• Press the “Start delay
up to 23 hours.
• Press the
“Start”
button.
The countdown of the delay time begins; the clock
symbol next to the delay time and the dot between
hours and minutes flash.
• The time delay indication
programme starts and it is replaced by the remaining
programme time.
• Once having pressed the
“Start”
button, the numb
of hours preselected can be reduced by pressing and
holding the “Start delay
delay time can also be reduced by minutes.
T
..before you press the “Start” button:
• S
“Reset”
button.
..after having pressed the “Start” button:
• P
“Reset”
button for at least 3 seconds - the
start delay time disappears from the display
Open the tap and press the
“Start”
button. The blue light
under the
“Start”
button is on. The programme
sequence indicator shows the current programme phase,
running from left to right through Wash, Rinse, Spin/Drain.
Before starting and after end of a programme, the sym
lights to show that the door can be opened. As long as a
wash programme is running, the door remains locked and
must on no account be forced open. In case you have an
urgent need to open it during a running programme, refer
to “Cancel (Reset) a running programme before the end”.
You can lock the buttons of the control panel against
improper use (e.g. by children).
• Press the temperature and the spin speed button
simultaneously and
The key symbol on the displa
• T
“Water tap closed”
The appliance has no or insufficient water supply. Open
the water tap; if the indication still lights up, refer
“Troubleshooting Guide” in the Instructions for Use.
“Clean pump”
Waste water is not pumped out. Check whether the drain
hose is kinked or the filter must be cleaned; in the latter case
refer to the Instructions for Use (“Removing the Filter”).
“Service”
Lighting up of the “Service” indication can be caused by a
fault in an electrical component. Refer to the
“Troubleshooting Guide” in y for Use; if
the fault persists, contact our After Sales Service
• The symbols of the programme sequence indicator
are dark, and the “Door open lights up.
1. Turn the programme selector to the “Off/O” position.
2. Clo
3. Open the door and unload the machine.
4. Le
1. Press
“Start”
button to pause the programme.
The light flashes.
2. Selec
and another spin speed if you want.
3. Press the
“Start”
button again. The new programme
continues at the same position where the previous
programme was interrupted. Do not add deterg
for this programme.
The
“Reset”
button cancels a programme before the end.
• Press the
“Reset”
button for at least 3 seconds;
“
drained out before the door can be opened. Caution!
The washing might still be hot.
START DELAY
PRO
“DOOR OPEN” INDICATION
CHILD LOCK
RED INDICA
PROGRAMME END
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
CANCEL (RESET) A RUNNING
PROGRAMME BEFORE THE END
40105431GB.fm Page 2 Thursday, September 20, 2007 2:56 PM
Black process 45.0° 100.0 LPI
