743390
2
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
CABLE TESTER CT100
2
1. INTRODUCTION
Congratulations! With the CT100, you have purchased an indispen-
sable tool that enables you to easily check the most common cables
used by musicians and sound engineers. Faulty cables are a
common cause of failure in live and studio situations. This micro-
processor-controlled device was designed to ensure fast, reliable
problem location. Various test modes and the included belt clip add to
its flexibility.
2. CABLE TESTER MODE
+ Move the ON switch to the CABLE TESTER position.
Insert one end of your cable into any OUT jack of the CT100. Connect
the other end of the cable to any IN jack. The LEDs will indicate which
input pins are connected to each output pin. Additionally, the
GROUNDED SHIELD LED indicates whether a XLR OUT jacks shield
is connected to the pin 1/sleeve signal.
2.1 How to test intermittent connections
The following method allows you to detect intermittent connections
caused by wire breaks or faulty solder points. While in CABLE TESTER
MODE, press RESET to store the current cable-wiring display and to
clear the INTERMITTENT LEDs. Move the cable vigorously in all
directions and watch the LEDs. Any change in wiring or break in the
signal flow will cause the LED of the corresponding input pin to light
up. The LED will stay lit until RESET is pressed again, assuring
detection of even the shortest breaks in the signal flow. It is a good
idea to repeat the test after resetting the LEDs to double-check the
initial results.
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Behringer CT100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Behringer CT100

Behringer CT100 Bedienungsanleitung - Holländisch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info