Bedienungsanleitung BEKO BL20 (Seite 4 von 12) (Englisch)

556799

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

TRANSPORTATION INSTRUCTIONS

1. The appliance should be transported only in a vertical upright position. The

packing as supplied must be intact during transportation.

3. Failure to comply with the above instructions could result in damage occuring

to the appliance. The manufacturer will not be held responsible if these

instructions are disregarded.

4. The appliance must be protected against rain, moisture and other

atmospheric influences.

IMPORTANT : Care must be taken while cleaning / carrying the appliance to

avoid touching the bottom of the condenser metal wires at the back of the

appliance as you might injure your fingers and hands.

Important : This appliance is not designed for stacking with any other

appliance.

When positioning your appliance, take care not to damage your flooring, pipes,

wall coverings etc. Do not move the appliance by pulling by the door or handle.

Do not attempt to sit or stand on top of your appliance as it is not designed for

such use. You could injure yourself or damage the appliance.

"IMPORTANT: Make sure that mains cable is not caught under the appliance

during and after carrying / moving the appliance, to avoid the mains cable

becoming cut or damaged."

If during the course of transport the appliance has to be transported horizontally,

it must only be laid on its left hand side when standing in the front of the

appliance. After bringing it to upright position,it must not be operated for at least

4 hours to allow the system to settle.

Empty any water in the drain tray before moving see section “Defrosting” and

“Cleaning & Care” for further information.

IMPORTANT : Make sure the plastic evaporating pan at the back of the product

collects water properly.

Do not allow children to play with the appliance or tamper with the controls.

BEKO plc declines to accept any liability should the instructions not be followed.

IMPORTANT

INSTALLATION INSTRUCTIONS

To avoid any loss in performance, air suction channels should not be obstructed. (140 cm

)

Minimum distance between the wall and the appliance must be at least 10 mm.

1. To avoid a hazard due to instability of the appliance, it must be fixed in accordance

with the instructions.

2. Do not operate this applliance unlees installed to furniture.

3. The appliance should be located on a smooth surface. The four front and back feet can

be adjusted as required. To ensure that, your appliance is standing upright adjust the four

front and back feet by turning clockwise or anti-clockwise, until the product is in firm contact

with the floor. Correct adjustment of feet avoids excessive vibration and noise.

4. Refer to "Cleaning and Care" section to prepare your appliance for use.

5. This appliance has been designed to operate in ambient temperatures between +10

and +32 degrees C (50 and 90 degrees F). There fore if the appliance is installed in an

unheated / cold room (E.g.: Conservatory /annex / shed / garage etc.) then the appliance

may not operate and as a result the storage time of food may be reduced.

10 mm

40 mm 40 mm

10 mm

Wall

Appliance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO BL20 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info