Bedienungsanleitung BEKO WMY 71432 LMB3 (Seite 73 von 75) (Deutsch, Englisch, Holländisch, Französisch)

579384

Zoom out

Zoom in

Vorherige Seite

1/75

Nächste Seite

73 / EN

Washing Machine / User’s Manual

4 Replace the gaskets and filters carefully in their places

and tighten the hose nuts by hand.

5.5 Draining remaining water and cleaning the

pump filter

The filter system in your machine prevents solid items

such as buttons, coins and fabric fibers clogging the pump

impeller during discharge of washing water. Thus, the water

will be discharged without any problem and the service life

of the pump will extend.

If the machine fails to drain water, the pump filter is clogged.

Filter must be cleaned whenever it is clogged or in every 3

months. Water must be drained off first to clean the pump

filter.

In addition, prior to transporting the machine (e.g., when

moving to another house) and in case of freezing of the

water, water may have to be drained completely.

WARNING: Foreign substances left in the pump

filter may damage your machine or may cause noise

problem.

WARNING: If the product is not in use, turn the tap

off, detach the supply hose and drain the water inside

the machine against any freezing possibility in the

region of installation.

WARNING: After each use close the supply hose tap

of the product.

In order to clean the dirty filter and discharge the

water:

1 Unplug the machine to cut off the supply power.

WARNING: Temperature of the water inside the

machine may rise up to 90 ºC. To avoid burning risk,

clean the filter after the water in the machine cools

down.

2 Open the filter cap.

3 Some of our products have emergency draining hose and

some does not have. Follow the steps below to discharge

the water.

Discharging the water when the product has an

emergency draining hose:

a Pull the emergency draining hose out from its seat

b Place a large container at the end of the hose. Drain the

water into the container by pulling out the plug at the end

of the hose. When the container is full, block the inlet

of the hose by replacing the plug. After the container is

emptied, repeat the above procedure to drain the water in

the machine completely.

c When draining of water is finished, close the end by the

plug again and fix the hose in its place.

d Turn the pump filter to take it out.

Discharging the water when the product does not

have an emergency draining hose:

a Place a large container in front of the filter to catch water

from the filter.

b Loosen pump filter (anticlockwise) until water starts to

flow. Fill the flowing water into the container you have

placed in front of the filter. Always keep a piece of cloth

handy to absorb any spilled water.

c When the water inside the machine is finished, take out

the filter completely by turning it.

4 Clean any residues inside the filter as well as fibers, if

any, around the pump impeller region.

5 Install the filter.

6 If the filter cap is composed of two pieces, close the filter

cap by pressing on the tab. If it is one piece, seat the tabs

in the lower part into their places first, and then press the

upper part to close.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMY 71432 LMB3 Seite 73

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info