Bedienungsanleitung Bestway 56283 My First Frame (Seite 1 von 28) (Alle Sprachen)

686195

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Refer to the item name or number stated on the packaging.

Packaging must be read carefully and kept for future reference.

56283

Item Aged

Over 2 years

MY FIRST FRAME POOL

OWNER’S MANUAL

WARNING

Never leave your child unattended – drowning hazard.

• Only for domestic use.

• Only for outdoor use.

• Children can drown in very small amounts of water. Empty the pool when not

in use.

• Do not install the paddling pool over concrete, asphalt or any other hard

surface.

• Place the product on a level surface at least 2 m from any structure or

obstruction such as a fence, garage, house, overhanging branches, laundry

lines or electrical wires.

• Recommend back towards the sun when playing.

• Modification by the consumer of the original paddling pool (for example the

addition of accessories) shall be carried out according to the instructions of

the manufacturer.

• Keep assembly and installation instruction for future reference.

Preparation

A single-handed installation of a small swimming pool usually takes only 10

minutes. Recommendations regarding placement of the pool:

• It is essential for the pool to be set up on solid, leveled ground. If the pool is

set up on uneven ground it can result in collapse and flooding, causing

serious personal injury and/or damage to personal property. Setting up on

uneven ground will void the warranty and service claims.

• Do not set up on driveways, decks, platforms, gravel or asphalt. Ground

should be firm enough to withstand water pressure; mud, sand, soft / loose

soil or tar are not suitable.

• Ground must be cleared of all objects and debris including stones and twigs.

• Check with your local city council for by-laws relating to fencing, barriers,

lighting and safety requirements and

ensure you comply with all laws.

Installation

Assembly can be completed without

tools.

NOTE: It is important to assemble pool

in the order shown below. Adult

assembly required.

1. Take the pool and accessories out of the carton with care. Spread the pool

out onto the selected site.

2. Close the water valve.

3. Insert all the Top Rails into the pole sleeve on the top of the pool. (Fig.1)

Please see the structure photo for detailed directions.

4. Insert both ends of Top Rails into the Connector. Then insert Bolt into the

top of the Connector. (Fig.2) Repeat this procedure for remaining parts.

(Fig.3)

Note: In each Connector, ensure both Top Rails are properly inserted.

5. Attach all Footings to the bottom of the Vertical Pool Legs. Then insert the

Vertical Pool Legs into the bottom of the Connectors. (Fig.4)

6. Test frame to ensure all connections are secure before filling with water.

(Fig.5)

7. Add 1’’ (2 cm) of water into the pool to cover floor. Once pool floor is slightly

covered, gently smooth out all wrinkles. Start at the center of the pool and

work your way clockwise to the outside.

8. Continue to fill the pool until it reaches the water fill line located on the

pool’s interior. Please kindly pay the upmost attention to not over fill the

pool for security reasons.

Dismantling

1. Open water valve on the bottom of the pool, water will drain automatically.

(Check local regulations for drainage by-laws). Then dismantle pool frame

to release water. Make sure you release most of the water within 20 minutes.

Note: Only adults should drain the pool!

2. Air dry the pool.

ATTENTION: Do not leave the drained pool outside.

Repair

If your pool is damaged, use the provided repair patch.

1. Clean area to be repaired.

2. Carefully peel patch.

3. Press patch over area to be repaired.

4. Wait 30 minutes before inflation.

Pool Maintenance

Warning: If you do not adhere to the maintenance guidelines covered here in,

your health might be at risk, especially that of your children.

• Change the pool water frequently (particularly in hot weather) or when

noticeably contaminated, unclean water is harmful for the users.

• Please contact your local retailer for chemicals to treat water in your pool.

Be sure to follow the chemical manufacturer’s instructions.

• Proper maintenance can maximize your pool’s lifespan.

• See packaging for water capacity.

Cleaning and Storage

1. After use, clean surfaces gently with a damp cloth.

Note: Never use solvents or other chemicals that may damage the product.

2. Remove all accessories and spare parts of the pool, clean and dry them.

3. Once pool is completely dry, sprinkle with talcum powder to prevent the

pool from sticking together and fold the pool carefully. If pool is not

completely dry, mould may develop, which will damage the pool liner.

4. Store liner and accessories in a cool, dry place out of children’s reach, with

a moderate temperature between 5°C / 41°F and 38°C / 100°F.

5. During rainy season, pool and accessories should be stored as instructed

above.

6. Improper draining of the pool might cause serious personal injury and/or

damage to personal property.

7. Check the product for damage at the beginning of each season and at

regular intervals when in use.

Ref#

Top Rail

Vertical Pool Leg

Connector

Bolt

Footing

Description Quantity

Parts:

Liner Underwater adhesive repair patch

A B

C D E

Drawings may not reflect actual product, not scaled to size.

Structure photo:

Fig. 1

Fig. 3Fig. 2

Fig. 5Fig. 4

Bestway 56283 My First Frame Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bestway 56283 My First Frame

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info