Bedienungsanleitung Beurer IH 30 (Seite 66 von 68) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Türkisch, Schwedisch)

568806

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Electromagnetic Compatibility Information

Table 1

For all ME EQUIPMENT and ME SYSTEMS

Guidance and manufacturer’s declaration – electromagnetic emissions

The IH30 is intended for use in the electromagnetic environment specied below. The customer or the

user of the IH30 should assure that it is used in such an environment.

Emissions test Compliance Electromagnetic environment – guidance

RF emissions CISPR 11 Group 1 The IH30 uses RF energy only for its internal function.

Therefore, its RF emissions are very low and are not

likely to cause any interference in nearby electronic

equipment.

RF emissions CISPR 11 Class B The IH30 is suitable for use in all establishments, inclu-

ding domestic establishments and those directly con-

nected to the public low-voltage power supply network

that supplies buildings used for domestic purposes.

Harmonic emissions

IEC 61000-3-2

Class A

Voltage uctuations/icker

emissions IEC 61000-3-3

Complies

Table 2

For all ME EQUIPMENT and ME SYSTEMS

Guidance and manufacturer’s declaration – electromagnetic immunity

The IH30 is intended for use in the electromagnetic environment specied below. The customer or the

user of the IH30 should assure that it is used in such an environment.

IMMUNITY test IEC 60601 test level Compliance level Electromagnetic environment

– guidance

Electrostatic

discharge (ESD)

IEC 61000-4-2

± 6 kV contact

± 8 kV air

± 6 kV contact

± 8 kV air

Floors should be wood, con-

crete or ceramic tile. If oors

are covered with synthetic

material, the relative humidity

should be at least 30 %.

Electrical fast transi-

ent/burst

IEC 61000-4-4

±2 kV for power sup-

ply lines

±2 kV for power sup-

ply lines

Mains power quality should be

that of a typical commercial or

hospital environment.

Surge IEC 61000-4-5

±1 kV line(s) and neu-

tral

±1 kV line(s) and neu-

tral

Mains power quality should be

that of a typical commercial or

hospital environment.

Voltage dips, short

interruptions and

voltage variations on

power supply input

lines IEC 61000-4-11

<5 % U

(>95 % dip

in U

) for 0,5 cycle 40

% U

(60 % dip in U

)

for 5 cycles 70 % U

(30 % dip in U

) for 25

cycles <5 % U

(>95

% dip in U

) for 5s

<5 % U

(>95 % dip

in U

) for 0,5 cycle 40

% U

(60 % dip in U

)

for 5 cycles 70 % U

(30 % dip in U

) for 25

cycles <5 % U

(>95 %

dip in U

) for 5s

Mains power quality should be

that of a typical commercial or

hospital environment. If the user

of the IH30 requires continued

operation during power mains

interruptions, it is recommen-

ded that the IH30 be powered

from an uninterruptible power

supply or a battery.

Power frequency

(50/60 Hz) magnetic

eld IEC 61000-4-8

3 A/m 3 A/m

Power frequency magnetic

elds should be at levels cha-

racteristic of a typical location

in a typical commercial or hos-

pital environment.

NOTE: U

is the a.c. mains voltage prior to application of the test level.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beurer IH 30 Seite 66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info