CLEANING AND MAINTENANCE
• Always unplug the fan before cleaning.
• Do not allow water to drip on or into the fan
motor housing.
FITTING A REPLACEMENT PL
FOR U
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by a
plug of the correct type. Please refer to
"Installation of a plug" below
Installation of a plug Applicable to U.K.
and Ireland.
WARNING - THIS APPLIANCE MUST BE
EARTHED.
The wires in the mains lead are coloured as such:
GREEN AND -
BROWN - LIVE
BLUE -
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug.
Please proceed as follows:
The wire which is coloured GREEN
must be connected to the terminal which is marked
with the letter 'E' or by the earth symbol or
coloured GREEN
The BROWN coloured wire must be connected
to the terminal, which is marked with the letter
"L" or is coloured RED.
The BLUE coloured wire must be connected to
the terminal, which is marked with the letter "N"
or is coloured BLACK.
NOTE: If the terminals in the plug are not marked
or if you are unsure or in doubt about the installation
of the plug please contact a qualified electrician.
If a 13A 3-pin plug is fitted, it must be an
approved plug, conforming to BS1363 standard.
Replacement 3A fuses must be BSI or
BS1362 approved.
GU
PLEASE KEEP YOUR RECEIPT AS THIS WILL
BE REQUIRED FOR
GUARANTEE.
• This product is guaranteed for 3 years.
• In the unlikely event of breakdown, please take
it back to the place of purchase, with your till
receipt and a copy of this guarantee.
• The rights and benefits under this guarantee
are additional to your statutory rights which
are not affected by this guarantee.
• Holmes Products Europe undertakes within
the specific period, to repair or replace free of
charge, any part of the appliance found to be
defective provided that:
• We are promptly informed of the defect.
• The appliance has not been altered in
any way or subjected to misuse or
repair by a person other than a person
authorised by Holmes Products
Europe.
• No rights are given under this guarantee to a
person acquiring the appliance second hand
or for commercial or communal uses.
• Any repaired or replaced appliance will be
guaranteed on these terms for the remaining
portion of the guarantee.
THIS PRODUCT IS MANUF
COMPL
73/23/EEC, 89/336/EEC
Waste electrical products should
not be disposed of with
Household waste.
Please recycle where facilities
exist.
Check on the following website
for further recycling and WEEE
information:
www
info-europe@jardencs.com
PRIÈRE DE LIRE ET DE CONSERVER
CES INSTRUCTIONS IMPORT
Lorsque vous utilisez des appareils électriques,
prenez toujours des précautions de sécurité de
base, en particulier les suivantes :
• Utilisez le ventilateur uniquement aux fins
décrites dans la notice d’utilisation.
• Pour vous protéger des risques de choc
électrique, n’immergez pas le ventilateur
la prise d’alimentation ou le câble électrique
dans l’eau ou tout autre liquide.
• Exercez une surveillance étroite lorsque
l’appareil est utilisé par des enfants ou près
d’eux.
• Débranchez l’appareil de la prise murale lorsque
vous ne l’utilisez pas, lorsque vous le déplacez
d’un endroit à l’autre, avant de mettre des
pièces ou d’en enlever et avant le nettoyage.
• Evitez tout contact avec les pièces mobiles
de l’appareil.
3 amp
FRANÇAIS
3
PLEASE READ AND SA
IMPORT
When using electrical appliances, basic safety
precautions should always be taken including
the following:
• Use the fan only for purposes described in
the instruction manual.
•To protect against electrical shock, do not
immerse the fan, plug or mains cable in
water or spray with liquids.
• Close supervision is necessary when any
appliance is used by or near children.
• Unplug from the electrical outlet when not in
use, when moving the fan from one location
to another
parts and before cleaning.
•Avoid contact with any moving parts.
• Do not operate in the presence of explosives
and/or flammable fumes.
• Do not place the fan or any parts near an
open flame, cooking or other heating
appliance.
• Do not operate any appliance with a
damaged mains cable, plug, after the
appliance malfunctions, or has been
dropped/damaged in any manner
• The use of attachments not recommended or
sold by the appliance manufacturer may
cause hazards.
• Do not let the mains cable hang over the
edge of a table or counter
contact with hot surfaces.
•To disconnect from the electrical supply
the plug and pull from the wall outlet. DO
NOT pull on the mains cable.
• Always use on a dry
• Do not operate without the fan grills properly
in place.
• This product is intended for household use
ONL
applications.
• Should the appliance stop working, first
check the fuse in the plug (UK only) or
fuse/circuit breaker at the distribution board is
operating, before contacting the manufacturer
or service agent.
• If the supply cord or plug is damaged, it must
be replaced by the manufacturer or its
service agent or a similarly qualified person
in order to avoid hazard.
• The appliance contains no user serviceable
parts and should the product suffer damage
or breakdown it must be returned to the
manufacturer or its service agent.
• Do not use outdoors.
• The fan should not be operated without its
base fitted.
• The fan should not be operated laying on its
side.
• NOTE: Use caution when adjusting the tilt
angle of the fan head to ensure that your
fingers do not get caught.
MISSING A P
Please call 0800 052 3615 for assistance.
ASSEMBL
Please see pictures on inside cov
pages (Fig. 1 - 12)
1. Assembly requires the use of a Phillips head
screwdriver and wrench.
2. In Figure 7, insert Bolt (D) and attach Screw
(K). Thread
of (D). Secure Locking Screw (J) last.
3. Before proceeding with Figure 1
protective sleeve from the motor shaft.
4. In Figure 12, there are 2 indentations in the Grill
Ring (T). Make sure that the rear grill sits in the
rear indentation and the Clip (W) is positioned
at the bottom of the grill. Slide the bottom of the
Front Grill (S) into the front indentation of the
Grill Ring. Working from the bottom, snap the
Front Grill into the Grill Ring. V
grills fit evenly into the indentations in the Grill
Ring and tighten Screw (U).
OPERA
1A & 1)
Speed Control (X) =
0 -
I -
II -
III -
ADJUSTMENT INSTRUCTIONS
Tilt Adjustment
Loosen T
to desired angle, and tighten T
Knob (E) to lock in place.
Height Adjustment
Loosen Pole Locking Knob (F), adjust Pole (G)
to desired height, and tighten Pole Locking Knob
(F) to lock in place.
Oscillation Adjustment
Press, Pull Oscillation (Y) = start, stop
ENGLISH
2
BASF40B/WI06MLM1.qxd 11/14/06 4:38 PM Page 7
