Bedienungsanleitung Bionaire BD20 (Seite 2 von 14) (Englisch, Dänisch, Französisch, Schwedisch, Norwegisch, Finnisch)

674380

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

ENGLISH

PLEASE READ AND SAVE THESE

IMPORTANT INSTRUCTIONS

NOTE: Before reading these

instructions, please review the

corresponding illustrations.

Description of Appliance (See Figure 1)

1. Control Panel

2. Air Oscillator

3. Handle

4. Air Intake Slats

5. Water Reservoir

6. Drain Plug

7. Water Level Pane

8. Drainage Hose

Control Panel (See Figure 2)

A. On/Off Button

B. Auto Button

C. Continuous Operation Button

D. Timer Button

E. Oscillation Button

F. Humidity Control Buttons

LCD Display (See Figure 3)

a. Speed

b. Water Reservoir Full

c. Continuous Dehumidification

d. Timer

e. Oscillation

f. Automatic Defrost

g. Whisper Quiet Automatic Dehumidification

h. Ambient Temperature

i. Automatic Dehumidification

j. Ambient Humidity Level

SAFETY PRECAUTIONS

When using electrical appliances, basic safety

precautions should always be followed to reduce

the risk of fire, electric shock, and injury to

persons, including the following:

1. Read all instructions before using the

appliance.

2. To avoid fire or shock hazard, plug the

appliance directly into an electrical outlet

and fully insert the plug.

3. Keep the cord out of heavy traffic areas. To

avoid fire hazard, NEVER put the cord under

rugs, or near radiators, stoves, or heaters.

4. DO NOT place dehumidifier near heat

sources such as stoves, radiators, and

heaters. Do locate your dehumidifier on an

inside wall near an electrical outlet. The

dehumidifier should be at least 10cm/4”

away from the wall for best results.

5. NEVER drop or insert any object into any

openings.

6. DO NOT operate any appliance with a

damaged cord or plug, after the appliance

malfunctions, or if it has been dropped or

damaged in any manner. Return appliance

to manufacturer for examination, electrical or

mechanical adjustment, or repair.

7. Use appliance only for intended household

use as described in this manual. Any other

use not recommended by the manufacturer

may cause fire, electric shock, or injury

to persons. The use of attachments not

recommended or sold by Holmes Products

(Europe) Ltd. may cause hazards.

8. DO NOT use outdoors.

9. Always place dehumidifier on a firm, flat,

level surface. A waterproof mat or pad is

recommended for under the dehumidifier.

NEVER place it on a surface that may

become damaged by exposure to water and

moisture (i.e. finished floor).

10. Dehumidifier should be unplugged when not

in use.

11. NEVER tilt, move, or attempt to empty unit

while it is operating. Shut off and unplug

before removing the water tank and moving

the unit. DO NOT attempt to remove the

water tank within 15 minutes after the

dehumidifier is turned off and unplugged.

Serious injury may result.

12. This dehumidifier requires regular

maintenance to operate appropriately. Refer

to cleaning and maintenance procedures.

13. NEVER use detergents, petrol, glass cleaner,

furniture polish, paint thinner, or other

household solvents to clean any part of the

dehumidifier.

14. DO NOT attempt to repair or adjust any

electrical or mechanical functions on this

unit. The inside of the unit contains no user

serviceable parts. All servicing should be

performed by qualified personnel only.

15. If the supply cord is damaged, it must be

replaced by the manufacturer or its service

agent or a similarly qualified person.

16. This appliance is not intended for use by

persons (including children) with reduced

physical, sensory or mental capabilities,

or lack of experience and knowledge,

unless they have been given supervision or

instruction concerning use of the appliance

by a person responsible for their safety.

Children should be supervised to ensure that

they do not play with the appliance.

Fig. 1

17. CAUTION: In order to avoid a hazard

due to inadvertent resetting of the thermal

cutout, this appliance must not be supplied

through an external switching device, such

as a timer, or connected to a circuit that is

regularly switched on and off by the utility.

PLEASE SAVE THESE INSTRUCTIONS

Please note that this is an electrical

appliance, and requires attention when

in use.

HOW YOUR DEHUMIDIFIER WORKS

Your Bionaire™ dehumidifier draws moisture

laden air through the intake grill on the top of the

appliance. Humid air passes through refrigerated

coils where the moisture is removed and

collected in the water reservoir.

For optimum performance, it is not

recommended to use this appliance in

environments where the temperature exceeds

37° C or is lower than 5° C.

The unit should only be used indoors in such

areas as a living room or bedroom. Never use

it outdoors. Make sure doors and windows are

closed before using the appliance.

PRE-OPERATING INSTRUCTIONS

1. Select a location for your dehumidifier, on a

flat/level surface, about 10 cm away from the

wall.

2. Place unit on a stable and flat floor surface.

If the floor surface is not even, there is a risk

the unit might be unstable or topple over.

Also, it may result in excessive vibration and

noise.

3. Plug the power cord into electrical outlet.

OPERATING INSTRUCTIONS

Automatic Dehumidifying

1. Plug unit into an appropriate electrical outlet.

The unit will beep 3 times. If open, the air

oscillator will return to its closed position.

2. Press the on/off button to start the unit.

The air oscillator will open to its maximum

position and the unit will start the automatic

dehumidification function.

3. The auto button enables you to select

between automatic dehumidification and

automatic whisper quiet dehumidification.

4. Press the auto button once to switch the

unit between automatic dehumidification and

whisper quiet dehumidification.

5. In automatic dehumidification mode, the

unit will monitor the relative humidity of the

environment and adjust its functionality

accordingly, cycling on and off to maintain

your desired comfort level.

6. In whisper quiet mode, the unit will operate

as in the automatic dehumidification mode

but at low speed. The quiet icon will be

highlighted in the LCD display.

7. The default humidity level is set at 60%

relative humidity (RH). Press the humidity

control buttons up and down to adjust the

humidity level as desired. Please refer to

the humidity control instructions below for

additional operating instructions.

8. To turn the unit off, press the On/Off button

again. The air oscillator will close and the

unit will stop working.

Continuous Dehumidifying

To set the unit to operate continuously, turn the

unit on and then press the continuous operation

button. The unit will operate in high speed, at

60% RH. When you activate this mode, the

continuous icon will be shown in the LCD display.

NOTE: If you adjust the humidity control buttons

during the continuous operation, the unit will

resume the automatic dehumidification mode.

NOTE: If continuous drain function is not in use

and the water reservoir is not manually emptied,

the unit will automatically shut off when the

water reservoir becomes full.

Using The Timer

Once the unit is powered on and an operating

mode is selected, press the timer button

continuously, choosing from 1 to 8 hours as

desired. The timer icon will be highlighted on

the LCD display and show the number of hours

remaining until the unit shuts off.

Oscillating Function

Press the oscillation button to set the air

oscillator to oscillate automatically between

45 and 90 degrees. Press again to select a

stationary position for the air oscillator at the

desired angle between 45 and 90 degrees.

Humidity Control

When the unit starts, the humidity level of the

environment will be shown on the LCD display.

1. For automatic or whisper quiet modes, press

the humidity control buttons to select the

desired humidity level. The control allows

you to adjust level in 5% intervals from 40%

to 80%.

2. If the unit humidity level sensor detects

humidity levels in the environment that are

lower than the selected humidity level, the

compressor will shut off and the fan will

work on low speed. The humidity level of

the environment must be higher than the

humidity level selected in order for the unit to

start operating again.

MODEL# BD20

Fig. 2 Fig. 3

Bionaire BD20 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info