Fig. 3
D
L
G
K
M
N
O
O
4 5
PLEASE READ AND SAVE THESE
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety
precautions should always be taken including
the following:
1. Before connecting the heater, check that the
voltage indicated on the rating plate
corresponds to the main voltage in your
home/office.
2. WARNING: Inordertoavoidoverheating,
donotcovertheheater( )Referenceto
product.
3. DO NOT position the heater directly under
a power socket.
4. DO NOT use this heater in the immediate
surroundings of a bath, a shower or a
swimming pool.
5. If the supply cord or plug is damaged, it must
be replacedby the manufacturer or its service
agentor similarly qualified person in order to
avoidhazard. The heater contains no user
serviceable parts. Should the product suffer
damage orbreakdown, it must be returned to
the manufacturer or their service agent.
6. Under the environment with electrical fast
transient, the product may malfunction.
7. DO NOT use this heater with a
programmer, timer or any other device
that switches the heater on automatically,
since a fire risk exists if the heater is
covered or positioned incorrectly.
8. Only touch the heater with dry hands.
9. DO NOT use this heater outdoors.
10.DO NOT position where it can be touched by
children, especially the very young.
11. Allow a safe area around the heater away
from furniture or other objects; at least 50 cm
from the top and sides and 200 cm at the
front. The heater is to be placed at least 3m
from water source.
12.DO NOT use this heater when it is lying on
its side.
13.DO NOT use the heater in rooms with
explosive gas (e.g. petrol) or while using,
oxygen, inflammable glue or solvent (e.g.
when gluing or varnishing parquet floors,
PVC etc.)
14.DO NOT insert any objects into the heater.
15.Keep the mains cord at a safe distance from
the main body of the heater.
16.If overheating should occur, the built-in
overheating safety device will switch off
the heater.
17.DO NOT place the cord under a rug.
18.The heater cannot be used adjacent to
curtains or combustible material. Curtains or
combustible material may be burned if the
heater was installed incorrectly.
19.This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
20.This heater is filled with a precise quantity of
special oil. Repairs requiring opening of the
oil container are only to be made by the
manufacturer or his service agent who
should be contacted if there is an oil leak;
21 When scrapping the heater, follow the
regulations concerning the disposal of oil.
DESCRIPTIONS (See Fig. 1, 2 & 3)
A. Heated Fins
B. Vents
C. Pull down handle
D. Front Panel
E. Cord Storage.
F. Power cord
G. Front castor assembly
H. Thermostat Knob
I. Power light
J. Control Knob
K. Front wing nut
L. Castor
M. Rear Castor assembly
N. Rear wing nut
0. U bolt
Technical Specifications
BOH1503
Wattage: 1500W
BOH2003/B
Wattage: 2000W
BOH2503
Wattage: 2500W
ASSEMBLY INSTRUCTIONS (See Fig. 3)
Please make sure the heater has not been
plugged into any electricity outlet.
Carefully remove heater from box. Some
accessories are packed internally. Please make
sure you have all of the following accessories
prior to throwing away packaging.
2 Castorassemblieswith four castors(M,G& L),
and
2 U Bolts with wing nuts (O, K, N).
ENGLISH
Note:This unit is for FLOORUSEONLY.
1. Turn the heater upside down and you will see
2 U bolt's (O) with wing nuts over the first and
last joint of the heater.
2. Unscrew the wing nuts (N & K) from the U-
bolts (O).
3. Start with the front of the unit and place one
hole of the front castor assembly (G) to the L
shape of the U-bolt (O) and the other hole of
the castor assembly into the other end of the
U-bolt, then screw on the wing nut (K).
4. Repeat step 3 for the rear castor assembly,
using wing nut (N) instead of wing nut (K) and
rear castor assemblies (M).
5. BOH1503 ONLY. Use your hand to press the
four castors (L) onto the four axes of the two
foot plates until you hear them click into
place. Use your hand to turn the castors and
if they move smoothly they have been
installed properly.
6.After installation of the front and rear castor
assemblies and the castors turn the heater the
rightway up: the heater is now ready for use.
NOTE:BOH1503 ONLY. Make surewhen
assembling that the castor assemblies with wheels
are pointing outward for maximum stability.
OPERATING INSTRUCTIONS
(See Fig. 1 & 2)
1. Set the unit to the OFF (O) position.
2. Plug in heater.
3. SettheThermostatKnob (H)allthewayto
theright.
4.Turn theControlKnob(J)todesiredlevelofheat.
BOH1503: 1 = 700W, 2= 800W, 3= 1500W
BOH2003/B: 1= 900W, 2= 1100W, 3= 2000W
BOH2503: 1= 1200W, 2= 1300W, 3= 2500W
NOTE:Whentheheaterisinuse,itis
normal that the heater cycles ON and OFF,
this is to maintain your desired temperature.
After using the heater, turn the Control Knob (J)
to “0” position, turn the Thermostat Knob (H) to
lowest temperature position and unplug the
heater from the socket.
SETTING THE THERMOSTAT
1. Set the Thermostat control allthe way to max.
2. When the desired temperature/comfort level is
reached, turn the thermostat control
anti-clockwise to a lower position or until the
heater stops operating.
3. The control will now automatically maintain
the pre-set temperature level by turning the
heater ON and OFF.
NOTE:ThePowerlightwillremainlitduring
operation.
NOTE:It isnormalfortheheatertocycleON
andOFFasitmaintainsthepresettemperature.
FROST GUARD INSTRUCTION
Plug the heaterin, then select the highest heat
setting (3), then turn thermostat knobto the lowest
temperature position( ), the temperature will be
maintained at 5° C,thus the heater willbe in the
off statusunless theroomtemperature is lower
than 5° C. If the room temperature is lower than
5° C, the heater will automatically start working
and will keep turning on & off all the time,
maintaining its ambient temperature of 5° C.
NOTE:Unitmustbeunpluggedforittobe
fully off.
TIP OVER PROTECTION
When the unit is accidentally knocked over, or
tilts on one side at more than a 45° angle; it
will instantly shut off. To reset, simply place the
heater in an upright position.
TRANSPORTING THE UNIT
Locate the pulldownhandle (C)above the control
panel. Pulldownto release andthengrasp the
handle. Pull the unit using the handle ensuring
that all castors are in contact with the floor.
NOTE:Donotusehandletolifttheproduct.
STORAGE TIPS
If the heater is not required for long periods, for
example during the summer, it should be stored
at room temperature; in a dry place and
preferably covered to prevent the accumulation
of dust and dirt.
GUARANTEE
Please keep your receipt as this will be required
for any claims under this guarantee.
This appliance is guaranteed for 5 years after
your purchase as described in this document.
During this guaranteed period, if in the unlikely
event the appliance no longer functions due to a
design or manufacturing fault, please take it
back to the place of purchase, with your till
receipt and a copy of this guarantee.
The rights and benefits under this guarantee are
additional to your statutory rights, which are not
affected by this guarantee. Only Holmes
Products (Europe) Ltd. (“Holmes”) has the right
to change these terms.
Holmes undertakes within the guarantee period
to repair or replace the appliance, or any part of
appliance found to be not working properly free
of charge provided that:
• you promptly notify the place of purchase
or Holmes of the problem; and
• the appliance has not been altered in any
way or subjected to damage, misuse,
abuse, repair or alteration by a person
other than a person authorised by Holmes.
