Bedienungsanleitung Bissel 2009 - StainPro 6 (Seite 8 von 11) (Englisch)

716412

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

www.BISSELL.com

IMPORTANT

Check for colourfastness in an inconspicuous place. If possible,

check upholstery stung. Coloured stung may bleed

through fabric when it becomes wet.

C-4 Empty the 2-in-1 water

tank/clean removable nozzle

1. Press power pedal

off. Remove 2-in-

1 water tank from base using tank carry

handle. Carry tank like a bucket to a utility

sink or outside where you will dispose of

dirty water.

2. Pull upward on bottom edge of latch in the

back of tank to unhook and remove lid.

3. Empty dirty water from back corner of

tank.

4. After each use, remove any debris trapped

in red lint screen on base of machine while

tank is still removed.

5. After each use, remove nozzle by

grasping each side of top of nozzle and

pulling forward. Clean nozzle by rinsing

under running water.

6. When finished, replace nozzle by slightly

raising front of machine to line up slots on

each side of the base with hooks on each

side of nozzle. Attach at base first and then

push forward to click nozzle into place.

NOTE: If nozzle is not attached properly,

loss of suction will occur.

7. To continue carpet cleaning, refer back to

“Carpet cleaning” instructions in section C-2.

If cleaning is complete, refer to “Maintenance

and care” instructions in section D.

C-5 Ready Tools™

Your deep cleaner comes equipped with

a hose and at least one attachment for

cleaning stairs, upholstery, and more.

Important! If using the machine to clean

upholstery, check upholstery tags.

1. Check manufacturer’s tag before cleaning.

“W” or “WS” on the tag means you can use

your deep cleaner. If the tag is coded with

“X” or “S” (with a diagonal strike through),

or says “Dry Clean Only,” do not proceed. Do

not use on velvet or silk. If manufacturer’s

tag is missing or not coded, check with your

furniture dealer.

2. Check for colourfastness in an

inconspicuous place.

3. If possible, check upholstery stuffing.

Coloured stuffing may bleed through fabric

when wet.

4. Plan activities to give upholstery time to

dry.

5. Vacuum thoroughly to pick up loose

debris and pet hair. Use a vacuum with a

brush attachment and a crevice tool to clean

in fabric folds and tufts.

6. To begin cleaning with attachments, follow

instructions in section C-1 for filling 2-in-1

water tank.

7. Set ReadyTools dial to TOOLS setting.

This will allow spray and suction from hose.

8. Attach cleaning tool of your choice to end

of hose. If using a Pet Stain tool or 3-in-1

Upholstery and Stair tool, follow directions

below.

9. Hold tool approximately 2.5 cm above

soiled surface. Press spray trigger to apply

cleaning solution to soiled area. Using brush

on tool, gently scrub area to be cleaned.

Release spray trigger, apply downward

pressure on tool and pull it toward you

to suction up dirt and cleaning solution.

Continue until no more dirt can be removed.

Caution: Do Not Overwet.

10. When finished cleaning, remove and rinse

tool(s) in clean, running water.

11. It is recommended that you suction clean

water from the tap to rinse out the hose. Be

careful not to over-fill your tank.

12. Before wrapping hose onto rack, lift end

of hose and stretch out to ensure all water is

cleared from hose.

13. Wrap hose around rack.

14. Empty 2-in-1 water tank and rinse out,

following instructions in section C-4.

15.

If ReadyTools dial becomes difficult to

turn, the diverter assembly that holds dial

may need to be cleaned. To clean, first

remove nozzle and locate screw that holds

diverter assembly in place. With a Phillips

screwdriver, remove the screw and set aside.

16. Remove diverter assembly; hold under

running water making sure water flows

through and around dial. Turn dial about 10

times clockwise and 10 more times counter

clockwise. This should free up any debris.

17. Wipe diverter assembly with a soft cloth

and place back on machine. Replace nozzle.

18. Return ReadyTools dial to FLOOR

CLEANING setting.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bissel 2009 - StainPro 6 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info