Bedienungsanleitung Black Decker BDV066 T2 (Seite 4 von 8) (Englisch)

581362

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

at least 15 minutes before restarting after a heat-related

shutdown. Unplug the appliance while cooling.

Connecting to a power source using the cables

Use the cables and connect the appliance directly to the

12 volt power source as follows:

X Make sure the appliance power is turned off and that no

flammable fumes are present in the installation area.

X Connect the red cable to the red terminal (7) marked (+)

on the back of the power inverter.

X Connect the black cable to the black terminal (7)

marked (-) on the back of the power inverter.

X Connect the red battery clamp (5) to the positive

terminal of the battery.

X Connect the black battery clamp (5) to the negative

terminal of the battery.

X Make sure that all connections between the battery

clamps (5) and the terminals (7) are secure.

X Switch the On/Off switch (3) to on and run the appliance

as normal.

Warning! Loose connectors may cause overheated wires

and melted insulation. Check to make sure you have not

reversed the polarity. Damage due to reversed polarity is not

covered by our guarantee.

Connection to load

The power inverter is equipped with a standard mains

socket (2). Plug the cord from the equipment you wish to

operate into the mains socket (2). Make sure that the load

requirement of your equipment does not exceed 400 watts.

The appliance is engineered to be connected directly to

standard electrical and electronic equipment in the manner

described above. Do not connect the appliance to household

ac wiring. Do not connect the appliance to any ac load circuit

in which the neutral conductor is connected to ground (earth)

or to the negative of the dc (battery) source.

Warning! Do not connect to ac wiring.

Hints for optimum use

For best operating results, the appliance should be placed

on a flat and/or solid surface. The appliance should only be

used in locations that meet the following criteria:

X DRY - Do not allow water or other liquids to come into

contact with the appliance.

X COOL - The surrounding air temperature should be

between -4°C and 40°C (-39°F and 105°F). Ideally

between 15°C and 25°C (60°F and 80°F). Keep the

appliance away from direct sunlight, when possible.

X WELL VENTILATED - Keep the area surrounding the

appliance clear to ensure free air circulation. Do not

place items on or over the appliance during operation.

The appliance will shut down if the internal temperature

gets too hot.

X SAFE - Do not use the appliance near flammable

materials or in any locations that may accumulate

flammable fumes or gases. This is an electrical

appliance that can briefly spark when electrical

connections are made or broken.

Warning! Rechargeable devices - Some rechargeable

devices do not operate well from a modified sine wave

inverter. They only operate correctly from a standard

household outlet which provides a pure sine wave.

Therefore, the manufacturer recommends that you operate

these types of devices from a standard household outlet

only, not from the appliance.

This problem does not occur with the majority of battery-

operated equipment. Most of these devices use a separate

charger or transformer that is plugged into an ac mains

socket. The appliance is easily capable of running most

chargers and transformers.

Troubleshooting

If the appliance On/Off switch (3) is on but there is no ac

output and the green power LED indicator (6) is not lit:

X Switch the On/Off switch (3) to off.

X Check that all the dc connections are connected

correctly.

X Check the tightness of the dc connections.

If the appliance On/Off switch (3) is on and the appliance

does not function but the red power LED indicator (6) is lit,

then one of the following conditions has occurred:

X Low battery voltage.

X Over voltage protection.

X Short circuit.

X Overload.

X Over temperature.

Switch the appliance On/Off switch (3) to off, correct the fault

and then switch the On/Off switch (3) to on.

Television interference

The power inverter is shielded to minimise interference with

TV signals. However, in some instances, some interference

may still be visible, particularly with weak TV signals.

Maintenance

Your Black & Decker tool has been designed to operate over

a long period of time with a minimum of maintenance.

Continuous satisfactory operation depends upon proper

care and regular cleaning.

Warning! Before performing any maintenance or cleaning

on the appliance, unplug the appliance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker BDV066 T2 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker BDV066 T2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info