Bedienungsanleitung Black Decker GTC650L (Seite 7 von 100) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

665802

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

ENGLISH

(Original instructions)

♦ Use your Black & Decker charger only to charge the

battery in the appliance/tool with which it was supplied.

Other batteries could burst, causing personal injury and

damage.

♦ Never attempt to charge non-rechargeable batteries.

♦ If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service

Centre in order to avoid a hazard.

♦ Do not expose the charger to water.

♦ Do not open the charger.

♦ Do not probe the charger.

♦ The charger must be placed in a well ventilated area

when charging.

Labels on the charger

The following symbols are found on your charger:

Your charger is double insulated; therefore no

earth wire is required. Always check that the

mains voltage corresponds to the voltage on the

rating plate. Never attempt to replace the charger

unit with a regular mains plug.

If the cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker

Service Centre in order to avoid a hazard.

The charger is intended for indoor use only.

Read the instruction manual before use.

Features

1. Front handle switch

2. Trigger switch

3. Lock-off button

4. Ventilation slots

5. Guard

6. Battery

7. Blade sheath

Fig. A

8. Charger

9. Charging indicator

Assembly

Warning! Before assembly, remove the battery from the tool.

Fitting and removing the battery (g. B)

♦ To t the battery (6), line it up with the receptacle on the

tool. Slide the battery into the receptacle and push until

the battery snaps into place.

♦ To remove the battery, push the release button (10) while

at the same time pulling the battery out of the receptacle.

Use

Warning! Let the tool work at its own pace. Do not

overload.

Charging the battery (g. A)

The battery needs to be charged before rst use and

whenever it fails to produce sufcient power on jobs that were

easily done before.

The battery may become warm while charging; this is normal

and does not indicate a problem.

Warning! Do not charge the battery at ambient

temperatures below 10°C or above 40°C. Recommended

charging temperature: approx. 24°C.

Note The charger will not charge a battery if the the cell

temperature is below approximately 10°C or above 40°C.

♦ The battery should be left in the charger and the

charger will begin to charge automatically when the cell

temperature warms up or cools down.

♦ To charge the battery (6), remove it from the tool and

insert it into the charger (8). The battery will only t into

the charger in one way. Do not force. Be sure that the

battery is fully seated in the charger.

♦ Plug in the charger and switch on at the mains.

♦ The charging indicator (9) will ash green continuously

(slowly).

The charge is complete when the charging indicator (9)

lights green continuously. The charger and the battery can

be left connected indenitely with the LED illumiated. The

LED will change to ashing green (charging) state as the

charger occasionally tops off the battery charge. The charging

iindicator (9) will be lit as long as the battery is connected to

the plugged-in charger.

♦ Charge discharged batteries within 1 week. Battery life

will be greatly diminished if stored in a discharged state.

Leaving the battery in the charger

The charger and battery pack can be left connected

indenitely with the LED lit. The charger will keep the battery

pack fresh and fully charged.

Charger diagnostics

If the charger detects a weak or damaged battery, the

charging indicator (9) will ash red at a fast rate. Proceed as

follows:

♦ Re-insert the battery (6)

♦ If the charging indicator continues ashing red at a fast

rate, use a different battery to determine if the charging

process works properly.

♦ If the replaced battery charges correctly, the original

battery is defective and should be returned to a service

centre for recycling.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GTC650L Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info