614794
9
Zoom out
Zoom in
Vorherige Seite
1/13
Nächste Seite
Verona CR 43
20
Tuning of Previous Station
Press rocker switch
/ 2 down. The
radio will automatically seek the previ-
ous station.
If the rocker switch
/ 2 is held
down/up, the seek operation continues
to be carried out quickly in the corre-
sponding direction.
Manual Tuning
It is also possible to tune in stations “by hand”
with this radio:
Press rocker switch <</>> 3 to the left
or to the right. The frequency band is
scanned in small steps.
Adjusting the Station Seek
Sensitivity
You may also modify the sensitivity of the
automatic station seek operation.
For this:
press lo rocker switch =.
If “lo” is indicated, only stations with
good reception conditions are captured
(lower sensitivity).
If “lo” is not indicated, stations with a
weaker reception are also captured
(higher sensitivity).
Adjusting the local mode sensiti-
vity
In regions with extremely high station densi-
ty, e.g. in Italy, the set allows you to switch
over the station seek sensitivity for the ocal
mode from “High” (adjusted ex works) to
“Low”. “Low” means that station seek tuning
only captures the most powerful stations.
For modifying the local mode:
press lo rocker switch = longer than
8 secs.
The display : shows “L” for “Low”.
By pressing lo rocker switch = again longer
than 8 secs., the set switches back to “High”
(display : “H”).
When switching off the unit or when removing
the set with the QuickOut handle the set
remains in the last activated mode.
Switching between Stereo and
Mono
If you wish to switch between stereo and
mono:
keep the lo rocker switch = pressed
for longer than 2 seconds. The stereo
symbol will appear in the display :
if the stereo mode is activated.
The stereo function is activated automatical-
ly when you turn your set on.
The set will automatically switch to mono if
reception is poor.
Storing a Station
You can store one MW and LW station and 4
FM stations on each of the preset buttons <.
The display will show you the selected wa-
veband (FM, MW or LW) and preset button.
On FM, the display will also give you the
chosen storage level (I, II, III or T).
If you wish to change from one storage level
to another:
press the FM•T button ?.
If you wish to store a station:
(for FM only) select the storage level.
To achieve this, press the FM•T button
? until I, II, III or T appears in the dis-
play :.
tune in the station (see chapter Station
Tuning).
press the desired preset button < until
the radio resumes play (approx. 2 se-
conds).
The display : indicates which preset
button has been pressed.
The station has now been stored.
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Blaupunkt VERONA CR 43 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Blaupunkt VERONA CR 43

Blaupunkt VERONA CR 43 Bedienungsanleitung - Deutsch - 13 seiten

Blaupunkt VERONA CR 43 Bedienungsanleitung - Holländisch - 13 seiten

Blaupunkt VERONA CR 43 Installationsanweisung - Alle Sprachen - 10 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info