Positioning the Appliance
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessa ry to dra in exces s water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The dra in hose must be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squash ed.
Syphon Connection
Extension Hose
If you need a drain hose extension , make sure to use a simi lar drain hose.
It must be no longer than 4 metres; oth erw ise the clean ing e ffect of the dishwasher could be reduced.
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equippe d with water supply and drain hoses that can
be positio ned either to the right or the le ft sides to facilitate proper installation.
The waste connection must be at a height of between 40 cm (minimum) and 100 cm (maximum)
from the bottom of the dish. The water drain hose should be fixed by a ho se clip. The free end of
the hose must no t be immersed in water.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwash er. If your sink
has one, it is recommended that the hose be disconnected and the hole plu gged.
Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.
Turn water fully on before starting the dishwasher.
1
Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
The safety supp ly hose consists of the double walls. The hose's system guaran tees its intervention by block ing the
flow of water in case of the supply hose breaking and when the air space between the supply hose itself and the outer
corruga ted hose is full of water.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
Unscrew the safety supply hose from the faucet.
3
2
1
2
3
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should no t be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the
minimum consult our Service Department for advice.
Connect the cold water supply hose to a threaded 3/4(inch) conn ector an d make sure that it is fastened tightly in place.
If the water pipes are new or have not been use d for an extended period of time, let the water run to make sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked
and damage the appliance.
