Bedienungsanleitung Bose Acoustimass 3 series V (Seite 7 von 100) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Finnisch)

704828

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

English - 7

Setting Up

Connecting the Acoustimass

module to your receiver or ampliﬁer

The speaker wires without plugs connect the Acoustimass module to your receiver or ampliﬁer. Your speaker system works with

receivers or ampliﬁers rated from 10 to 200 watts per channel with 4 to 8 ohm impedance. Refer to your receiver or ampliﬁer

owner’s guide.

CAUTION: Incorrect wiring results in little or no bass output and could damage the system.

1. Connect the speaker wires to the INPUTS FROM AMP OR RECEIVER terminals on the Acoustimass module’s rear panel:

A. Connect the marked wire to the positive (+) terminal of the L (left) pair of input terminals.

B. Connect the unmarked wire to the negative (–) terminal of the L (left) pair of input terminals.

C. Repeat steps A and B with the other speaker wire for the R (right) pair of input terminals.

– R +

– L +

OUTPUTS

TO C

E SPEAKERS

– R

– L

INPUTS

AMP OR RECEIVE

2. Connect the other ends of the cables to the speaker terminals of your ampliﬁer or receiver.

A. Connect the marked wire connected to the L (left) pair of input terminals on the module to the LEFT positive (+) terminal on your

ampliﬁer or receiver.

B. Connect the unmarked wire connected to the L (left) pair of input terminals on the module to the LEFT negative (–) terminal on

your ampliﬁer or receiver.

C. Repeat steps A and B with the wire connected to the R (right) pair of input terminals on your Acoustimass module and the

RIGHT pair of input terminals on your ampliﬁer or receiver.

– R +

– L +

OUTPUTS

TO C

E SPEAKERS

– R

– L

INPUTS

AMP OR RECEIVE

Before pluging in your receiver or ampliﬁer:

• Ensure no strands of wire from any terminal are brushing against any other terminal. Such “bridged” wires create short circuits which

can damage your receiver or ampliﬁer.

• Check all connections to avoid damaging your speakers. Make sure the speakers are connected to the module and not directly to the

ampliﬁer or receiver.

Checking the system

With your ampliﬁer and Acoustimass

module powered, your system should respond accordingly:

• With the balance control on your ampliﬁer turned to the left, sound comes from the Acoustimass module and left speaker only.

• With the balance control turned to the right, sound comes from the Acoustimass module and right speaker only.

• With the balance control in the center position, music with bass should be the same or louder with the control in the center than to the

left or right.

If your system does not respond as described, check all the wires for proper positive to positive and negative to negative connections.

If your system still doesn’t respond properly, see “Troubleshooting” on page 8.

Understanding automatic system protection

When played at high volume, your Acoustimass systems’ automatic protection circuit activates to prevent damage to the system from

electrical stress or overload. When this happens, you may notice a slight decrease in volume. This indicates that the power input may

have exceeded safe levels. Setting the volume at or above this level for sustained periods is not recommended.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bose Acoustimass 3 series V Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info