637445

Boss MR648S Seite 5

5
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
Page 7
20.SD CARD SLOT
When you need to play the file in the SD card ,insert the SD card into the SD
card slot ,the system will change into the SD mode automatically, and then
play the first file in the SD.
Note:
When SD card and USB stick are both inserted into their slot or socket ,
the system will change into the playback mode of the latter one.
Remove the two screws that protect
the CD player during transportation
before operating the player.
INSTALLATION METHOD
This is an anti-theft installation method.
The main unit wears a METAL MOUNTING SLEEVE.
Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna
according to the requirements of this Instruction Manual, then install the metal
mounting sleeve into the car as per the diagram illustrated below.
METAL
SUPPORT STARP
METAL MOUNTING SLEEVE
DASHBOARD
To raise the anti-skip capability of the unit,
please ensure the metal support strap is
connected firmly to the car chassis.
To properly fix the metal mounting
sleeve, bend the tabs of the sleeve
against the DASH BOARD with a
screwdriver.
FRONT PANEL
PLASTIC TRIM RING
UNIT CHASSIS
Before mounting and operating
the player, remove the metal
mounting sleeve illustrated by
the arrows.
NOTE
insert the two supplied keys into the left and right side
slots of the chassis at the same time.
To remove the CD player out of the mounting sleeve,
To attach the removable faceplate, insert the
right side of the faceplate into the right of the
CD player chassis first. Then push the left side
of the faceplate into the chassis until you hear
it “click”.
Page 4
2) AF [ALTERNATIVE FREQUENCIES]
When AF switching mode is selected and the state of AF switching mode is
displayed by AF segment in display.
Segment off: AF switching mode off.
Segment on: AF switching mode on, and has RDS information.
Segment flashing: AF switching mode on, but RDS information is not
received yet.
When AF switching mode is selected, the radio checks the signal strength of
AF all the time. The interval of checking time of each AFs depends on the
signal strength of current station, from a few minute for strong station to afew
seconds for weak station. Every time that new AF is stronger than current
station, it switches over to that frequency for very short time, and
NEW FREQUENCY is displayed for 1-2 seconds. Because the mute time of AF
switching or checking time is very short, it is almost inaudible in case of
normal program.
During FM mode, when AF is on, SEEK, (SCAN), AUTO-MEMORY function can
only receive and save RDS program.
3) TA SEEK/TAALARM:
TA SEEK mode: when newly tuned station does not receive TP information for
5 seconds, the radio retunes to next station which has a different PI to the last
station, but has the TP information.
When TP information gets lost at the current station for retune time which is
set by RETUNE SHORT(60 seconds) or RETUNE LONG(90 seconds), the
radio starts to retune to next same PI station. When same PI station does not
receive in 1 cyclic search, the radio retunes to next station with TP information.
TA ALARM mode: when this mode is selected, any automatic retune mode is
not activated. Only double beep sound(ALARM) will be heard.
When newly tuned station does not have TP information for 5 seconds, beeps
are sounded.
When TP information gets lost at the current station for retune time, the beep
soundwillbeheard.
When newly tuned station has no RDS signal, PI SEEK is suppressed .
4) PI SOUND/ PI MUTE:
PI SOUND mode: if a car cruises between buildings that could cause
reflecting signals, a phenomenon may occur, due to different PI codes being
received from the same AF source. when different PI sounds (DIP) are heard
occassionally, this will happen for less than 1 second.
PI MUTE mode: under above same situation, a mute sound will be heard for
less than1second.
5) RETUNE L / RETUNE S:
The initial time of automatic TA search or PI SEARCH mode is selected.
When PI information is not received for retune interval , the radio starts to
retune to next same PI station.
When same PI station does not receive 1 cyclic search, the radio goes to last
station and waits for 4-5 minutes until PI code is received.
RETUNE L mode: selected as 90 seconds.
RETUNE S mode: selected as 60 seconds.
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Boss MR648S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Boss MR648S

Boss MR648S Bedienungsanleitung - Spanisch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info