454263
5
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
5
Our products are engineered to meet the highest
standards of quality, functionality and design.
We hope you thoroughly enjoy your new Braun
appliance.
Carefully read the use instructions before use.
Important
Plug your hairdryer into an alternating current
(
Ù
) outlet only and be sure that your household
voltage corresponds to the voltage marked on
the hairdryer.
Do not allow the appliance to become
wet.
When using the hairdryer in a bathroom, always
unplug it after use. Even a switched-off hair-
dryer presents a hazard if not unplugged.
For additional protection, it is advisable to
install a residual current device (RCD) with a
rated residual operating current not exceeding
30 mA in the electrical circuit of your bath-
room. Ask your installer for advice.
Care should be taken not to block the inlet and
outlet grill when the hairdryer is switched on. If
either grill becomes blocked, the hairdryer will
automatically cut out. After cooling for a few
minutes, it will switch back on automatically.
Do not wrap the mains cord around the ap-
pliance. Regularly check the mains cord for
wear or damage, particularly where it enters the
product and the plug. If you have any doubt
about its condition take the appliance to your
nearest Braun Service Centre for checking/
repair. The mains cord of the appliance may
only be replaced by an authorised Braun
Service Centre. Unqualified repair work can
lead to extreme hazards for the user.
Description
1
Switch
2
Cold shot button
3
Long-life Filter
4
Concentrator nozzle
5
Diffusor attachment
Switch settings
1
Cold shot
2
To fix a style with cold air, press the cold shot
button.
Long-life Filter
3
Regularly wipe the filter clean. For a thorough
cleaning, remove the filter and clean it under
running water.
Concentrator nozzle
4
For precise styling use the concentrator nozzle.
Diffusor attachment
5
Attaching the diffusor
Align the notches on the rim of the diffusor
attachment with the slots in the hair dryer.
Push the attachment onto the hairdryer, then
turn clockwise until the bayonet lock clicks
into place.
•To remove the diffusor, turn in the opposite
direction and pull.
Volume styling
Short to mid-length hair:
To add volume and root lift, gently guide the
diffusor fingers with a small circular motion
over your scalp. Continue section by section.
Lon
g hair:
First dry hair ends by placing them onto the
finger plate. Then, with the diffusor, carefully lift
the hair to your head and hold. Finish off the
roots with a gentle circular movement of the
diffusor fingers on the scalp to add some lift.
Subject to change without notice.
This product conforms to the EMC-Directive
89/336/EEC and to the Low Voltage Regulation
73/23 EEC.
0 = off
1 = gentle drying
2 = fast drying
English
3514008_CPC1600DFB6 Seite 5 Montag, 20. Oktober 2003 8:43 08
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Braun CPC 1600 DFB6 Creation wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info