Bedienungsanleitung Bravilor Bonamat HWA20 (Seite 4 von 8) (Englisch)

545952

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Warning !

For safe operation of the water boiler, pay

close attention to the following points:

1. When the appliance is in operation, some

components will get very hot.

2. If the appliance is unused for a long period

of time, it is advisable to disconnect the

electricity and close the water supply.

3. Under normal circumstances, a small

quantity of water always remains in the

appliance. Please keep this in mind if it is

to be exposed to temperatures below 0

4. Stay with the appliance during

maintenance operations (such as

descaling).

5. When working with strong cleaning or

descaling agents, it is most advisable to

wear safety goggles (face protector) and

gloves.

6. Never immerse the appliance in water.

7. After working with strong cleaning or

descaling agents, be sure to wash your

hands.

8. Make sure that all repairs are carried out

by qualified technicians.

9. When the appliance has to be opened for

repairs or maintenance, be sure to

disconnect the electricity.

10. The appliance must always be connected

to the mains in such a way that it can be

easily disconnected.

11. The appliance should be connected to the

water mains with the hose attached to a

hand-operated tap.

12. The appliance must be earthed.

13. Be sure to observe local regulations and

standards when installing the appliance.

14. Prevent spillage of the descaler solution on

to the outside of the machine, this can

cause permanent damage to the exterior

surface of the machine housing. In the

event of a spillage, wipe area affected dry,

whilst observing the safety regulations as

given in the Users Instructions. Directly

afterward the area must be cleaned

thoroughly.

INSTALLATION AND INITIAL OPERATING PROCEDURE

When installing the appliance, keep the

instructions given in the

INTRODUCTION-

warning

(points 10 through 13)

in mind.

Installation

Position the appliance on a solid level base

where it can be easily connected to the

electrical and water mains.

Please take note of the following in regard to

figure 3:

If equipped with a fuse plug, the appliance

must be protected with a 13 A fuse.

If another plug is installed, the appliance

must be protected with a 15 A fuse.

If the plug supplied with the appliance

does not fit into your socket, it should be

cut off and replaced with a new plug The

old plug should then be disposed of, as it

can be dangerous if inserted into a socket.

Keep the following instructions in mind when

installing a new plug:

- The yellow-green core (earth) must be

connected to the terminal marked with

the letter E or the earth symbol ( ) or

coloured green or yellow-green.

- The blue core (neutral) must be

connected to the terminal marked with

the letter N or coloured black.

- The remaining brown core (live) must be

connected to the terminal marked with

the letter L or coloured red.

Fig.3 (220V 1 phase with plug connection)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bravilor Bonamat HWA20 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bravilor Bonamat HWA20

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info