Bedienungsanleitung Brinno BWC (Seite 6 von 8) (Englisch)

569556

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

On the front of the BirdWatchCam, at the bottom

under the bevel, there are three LED lights.

These LEDs allow you to monitor the status of the

camera without having to move the camera from its

mounted position.

Each LED supports a different function:

Green LED light: Power ON/OFF status

Red LED light: Low Battery Level

Blue LED light: Low Memory Level

BirdWatchCam Operation:

To turn on the BirdWatchCam:

Press and hold the orange power button on the front

of the camera until the green LED lights up.

NOTE: IF THE SD CARD IS FULL OR THE BATTERIES

ARE EMPTY THE CAMERA WILL NOT TURN ON.

After approximately one minute the green LED will

turn off and the camera is ready to detect motion.

NOTE: **The Green LED will also flash every 15

seconds to indicate that the camera is running

properly and is ready to take photos.

Anytime a bird ( or any warm-blooded creature )

enters the targeted capture area, the camera

will wake up and take 20 photos within approximately

20 seconds and then go back to sleep. This preserves

your batteries until the next activation.

The Green LED will turn on when motion is detected,

and will flicker for 20 seconds while pictures are

captured and stored on the SD memory card.

To turn off the BirdWatchCam, press and hold the

orange power button until the green LED flickers and

then turns off.

If the camera has turned itself off due to a low battery

or a nearly full SD card, the next time the power

button is pressed, the red or blue LED will turn on and

will stay on until the green LED flashes.

If the SD card is full or is missing, the blue LED will turn

on for a few seconds, and then the camera will turn off.

If the battery is too low, the red LED will turn on for a

few seconds then the camera will turn off.

Note: When the winds gust many birdfeeders

will swing and activate the BirdWatchCam. We

recommend turning o the BirdWatchCam when

the winds are high or gusting above 25 MPH, if your

bird feeder is free hanging.

It is not necessary to remove the mounting unit to

use the mounting methods noted below.

You may choose to use the mounting straps to

wrap around a tree or pole to mount the camera.

You may use the screw nail holes in the mounting

unit to hang the camera.

You may use the suction cups to adhere to a clean

flat surface. (we recommend using one of the straps

as a safety line when using the suction cups)

Once you have the BirdWatchCam mounted it can

be adjusted by releasing the locking mechanism

on the mounting unit by turning the friction lock

counterclockwise and swiveling it left or right and

up or down while holding the laser pointer button

down.

Once positioned correctly, simply lock it into

position by turning the friction lock clockwise.

We strongly suggest taking a series of test photos

to ensure that the BirdWatchCam is set up and

targeted properly.

Now you have the BirdWatchCam mounted where

you want it and its time to take pictures.

19.

22.

23.

24.

25.

26.

21.

20.

-04

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Brinno BWC Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info