Bedienungsanleitung Brinno GWC (Seite 5 von 9) (Englisch)

569541

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

10.After choosing the lens setting appropriate to

the subject to be photographed, the camera

should be aimed so that the lens is pointing at

the center of the subject. Because the field of

view of the lens is quite wide, the positioning

of the GardenWatchCam does not have to be

extremely precise. But because a typical time

lapse sequence takes place over a long period

of time, it is suggested that a short test

session (with a short time interval) be used to

ensure correct positioning of the Garden-

WatchCam. Once the positioning has been

verified, then the desired time interval for the

full time lapse sequence can be set, and its

time to take pictures.

0.5m / 19inch

1m / 39inch

2m / 78inch

3m / 118inch

36cm / 14inch

75cm / 29inch

146cm / 57inch

219cm / 86inch

30cm / 12inch

56cm / 22inch

110cm / 43inch

168cm / 66inch

The table above shows some typical distances, but since the GardenWatchCam is capable of focusing on

objects that are far away (in standard mode), the GardenWatchCam can also be used to photograph many

other subjects.

For example, you could set up the GardenWatchCam to take a photo once every 24 hours to capture the

process of a house being built over several months. Or get a picture of the sunset every day for a year.

The possibilities are only limited by your imagination and creativeness!

** Please note that the AVI files created by the GardenWatchCam can be viewed on the program

“GardenWatchCam Player” in the CD supplied with GardenWatchCam or using Windows media player, or

most other AVI players.

The table below shows the approximate image size (width x height) based

on the distance between the camera and the subject(s) to be captured.

Mode

Distance from Target

Area (Meter / Inch)

Target Area captured

Height (cm / inch)

Target Area captured

Width (cm / inch)

Macro view

Standard view

On the front of the GardenWatchCam, above the lens, there are three LED lights. These LEDs allow you

to monitor the status of the camera without having to move the camera from its mounted position.

Each LED supports a different function :

Green LED light：Power ON/OFF and Status

Red LED light：Low Battery Level

Blue LED light：Low USB flash drive Level

GardenWatchCam Operation

To turn on the GardenWatchCam

Press and hold the orange power button on the

front of the camera until the green LED lights up.

After a few seconds the GardenWatchCam will

beep twice to indicate it has properly initialized

and is waiting to start a time-lapse sequence.

After a delay of approximately 5 seconds the

GardenWatchCam will take the first picture of

the time-lapse sequence.

NOTE : If the USB flash drive is full, or the

batteries are completely empty, the Garden-

WatchCam camera will not turn on.

If the batteries are too low for normal operation,

the GardenWatchCam will turn on beep twice,

the red LED will turn on, and then the Garden-

WatchCam will beep six times and then turn off.

If the USB flash drive is full, or not installed, the

GardenWatchCam will turn on beep twice, then

after a few seconds the blue LED will turn on,

then the GardenWatchCam will beep six times

and then turn off.

During GardenWatchCam operation the Green

LED will turn on for about one

second every

15 seconds to indicate that the camera is

running properly and is ready to take

photos. If there is any other status to

report, the camera will do so at the same

time as the green LED flashes. If the

batteries

are getting low the red LED will turn

Beep voice:

Power On: 2 times beep

Power Off: 3 times beep

Error status: 6 times beep

( Error= No USB insert, USB memory short, Low battery)

on in unison with the green LED. If the USB flash

drive is getting close to being full, then the blue

LED will turn on in unison with the green LED.

If the camera has previously automatically shut

down due to low batteries or a full USB flash

drive, the next time the power button is pressed

the red or blue LED will turn on and will stay on

until the green LED turns on. This allows you to

determine the cause of the automatic shutdown

so that the appropriate corrective action can be

taken.

The Green LED will also turn on and flicker for a

few seconds while a picture is captured at the

chosen time setting, and then is stored on the

USB flash drive. This indication of GardenWatch-

Cam activity is independent of the status

indication that occurs every 15 seconds.

To turn off the GardenWatchCam

Press and hold the orange power button until

the GardenWatchCam beeps three times and the

green LED turns off. This may take several

seconds because the GardenWatchCam must

first power itself on and initialize before it

recognizes the turn off request. Please be

patient and wait for the beeps and LED

indication.

‧06 07‧

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Brinno GWC Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info