9.2 B
Product variant KING II:
Product variant KING II LS:
WPull the adjuster strap 16 straight
forward (not upwards or downwards)
1. Pull the adjuster strap 16 until the indicator light 15
illuminates “green“ and you can hear an audible
sound.
►The belt tensioning of your child seat is now active
and removes excess belt length automatically within
a dened working range.
TIP! T he green indicator light 15 t urns of
after a few seconds, but the system continues to work.
It is possible at any time to repeat step 1.
Y
within a dened working range in the harness once adjusted correctly and
also with indicator and alert functions. The system works with an occupant
sensor
DANGER! The automatic harness tensioning system and indicator and
alert functions operate within limits and subject to correct usage. They provide
assistance only and do not replace safety checks, recommendations or requi-
rements or negate responsibility for them. Y-
bility for and periodically check the safety of your child.
Product variant KING II
DANGER! When the indicator light 15 illuminates
red your child is not properly secured or the auto-
matic retraction system has reached its limit. Stop
at the next safe opportunity and repeat the steps of
the chapter “9.3 Securing your child“ .
TIP! If your child is still fastened, the alert can be
a warning that the automatic retraction system is at
the end of its working range. Y
well beyond your rst installation but the automatic
adjustment has stopped. Y
journey (with periodic checks on your child) or pullover
at the next convenient place and simply pull the adjus-
ter strap again (without unbuckling) to green to reload
your automatic retraction system, this will also reset
your alert system.
TIP! Y
sing and holding the mute button rst whilst undoing
the buckle.
DANGER! When the indicator light 15 ashes red
and green the batteries must be replaced.
Lift the seat cover and the foam cushion on the seating
surface and change the two type
battery compartment 24 .
8. INST
1. Place the child seat facing in the direction of travel
on the vehicle seat.
2. Push one of the grey release buttons 03 and at the
same time pull the seat shell 02 as far forward as
possible.
DANGER! When opening or closing, nothing must
come between the seat shell 02 and the seat base
06 . Y
injuring them.
3. Pull out the vehicle seat belt and place it between
seat shell 02 and seat base 06 through the two
lower light red belt guides 04 .
DANGER! Ensure that diagonal seat belt 21 and
lap belt 22 lie in both lower light red belt guides 04
and both belts are not twisted.
4. Engage the buckle tongue in the vehicle seat buckle
20 with an audible “CLICK“.
5. Tighten the diagonal belt section 21 by pulling
diagonal belt 21 strongly on the opposite side from
the vehicle seat belt buckle.
6. Hold the seat shell 02 with one hand while pulling
the grey adjustment lever 05 forward with the
other hand. T 02 against the seat
base 06 over both engagement positions.
W! T
from the grey adjustment lever 05 , as soon as
getting over the two engagement positions.
7. Push the seat shell 02 with both hands against the
seat base 06 until it is fully engaged.
DANGER! The two red safety markings on the
grey release buttons must not be visible.
8. Place the diagonal belt section 21 in the upper dark
red belt guide 01 .
9. Give the child seat a rm pull forwards to ensure
that it is securely fastened.
10. Observe the steps in the chapter
10.1 “ADJUSTING THE HEADREST“ .
1 Observe the steps in the chapter
10.2 “BUCKLE UP .
9. 1 ADJUSTING THE HEADREST
1. Loosening the harness
Press the adjustment button 13 and at the same time
pull below the shoulder pads 10 both shoulder straps
11 forward.
The headrest 09 must be adjusted so that the top of
the harness shoulder pads are in-line with your child‘s
shoulders.
If your child is wearing thick clothing you may need to
raise the headrest again to ensure correct positioning
of the harness.
2.
KING II
1. Sit your child in the seat and check the height of the
headrest 09 .
2. Pull / push the headrest adjuster 07 to move the
headrest up or down.
3. Repeat the procedure until the headrest 09 is at the
correct height.
W If the headrest is positioned too low
it can seriously compromise the effectiveness of the
harness, and indicator systems.
KING II
1. Pull the lever of the headrest adjuster 08 at the
rear of the seat shell 02
Now the headrest is unlocked.
2. Slide the unlocked headrest adjuster 09 into the
desired diection to the correct height.
you release the lever of the headrest adjuster 08 ,
the headrest 09 engages.
3. Sit your child in the seat and check the height of
the headrest 09 . Repeat the procedure until the
headrest 09 is at the correct height.
It is important to set the headrest 09 height position correctly for optimal
5-point harness operation and ensure the safety of your child.
T
The seat shell of the KING II /
8. Pull shoulder straps 11
to remove all slack from
the lap section ensuring
the harness lies at and
has a snug t.
1. Open the harness buckle 12 (press red button)
2. Press the adjusting button 13 and at the same time
pull below the shoulder pads 11 both shoulder
straps 10 forward.
3. Sit your child down in the seat.
4. Check the correct height of the headrest and adjust it
if necessary [see above].
5. Make sure that your child´s back lies at against the
backrest of the child seat.
6. Unhook the buckle tongues 23 from the harness
retainers 19 .
7. Guide the two buckle latches 23 together and engage
them before putting them into the harness buckle 12
- this should make an audible click.
DANGER! The lap belts 24 must be positioned as low as possible over
your child‘s hips.
9. Carry out the steps in section “9.3 SECURING YOUR CHILD“ for your
particular product variant.
1. Pull on the adjusting strap 16 until the harness lies
at and is close against your child‘s body
WPull the adjuster strap 16 straight
forward (not upwards or downwards).
1. Pull the adjuster strap 16 until the indicator light 14
illuminates “green“ and you can hear an audible
“Click“ which indicates that the harness is tightened
correctly
TIP! The green indicator light turns off automatically after
a few seconds.
2. Observe the safety notes in the chapter
“8. INST“
9.3 SECURING YOUR CHILD
WPull out the adjusting strap 16 straight
forward.
The more
protected. Therefore avoid putting thick clothes on your child under the belt.
2. Observe the safety notes in the chapter
“8. INST“
What to do when the indicator light does not illuminate “green“ ...
● Check if the headrest is adjusted correctly according to the chapter
“9.1 .
● Ensure that you have pulled the adjuster strap with enough force.
● In general the battery in the product is a non replaceable item and must not be
changed due to its long life.
● If the problem can not be resolved using the above methods, contact your
service representative or the BRIT
What to do when the indicator light does not illuminate at all...
● Check if the headrest is adjusted correctly according to the chapter “9.1
ADJUSTING THE HEADREST“.
● Check if there is any accumulation of dirt or foreign objects on the seating
area under the occupant sensor
If necessary clean the area as described in chapter 4 [page I].
● Replace both batteries
● Ensure that you have pulled the adjuster strap with enough force.
If the problem can not be resolved using the above methods, contact your service
representative or the BRIT
Please take the time to read these instructions carefully and keep
them to hand in the intended storage compartment 18 on the child
safety seat at all times! The instructions must be with the child safety
seat if the latter is passed on to a third party
DANGER! For the protection of your child:
• Use the KING II /
vehicle. It is in no way suitable as a seat or toy in the home.
child safety seat may be damaged without the damage becoming immediate-
ly visible. In this case the child safety seat must be replaced. Please dispose
of it properly
• Have your child safety seat checked as a rule if it was damaged (e.g if it
falls to the ground).
• Regularly check all important parts for damage. Ensure that all mechanical
parts, in particular
• Never lubricate or oil parts of the child seat.
•
Never leave your child unattended in the child seat in the vehicle.
• Let your child in and out of the vehicle from the pavement side as a rule.
• Protect the child safety seat against intensive direct sun radiation,
as long as it is not in use.The child safety seat can become very hot under
direct sun radiation. Child skin is sensitive and could thereby be injured.
•
The more snugly the harness ts over your child's body
be protected. Therefore avoid putting thick clothes on your child under the belt.
• T
nity to play around when removed from the child seat.
• Use on the rear seat: Push the front seat forwards sufciently so that the
feet of your child cannot hit the backrest of the front seat (to avoid the risk
of injury).
DANGER! For the protection of all vehicle occupants:
In the case of an emergency stop or an accident, unsecured persons or
objects may cause injury to other vehicle occupants. Please always check
that...
• the backrests of the vehicle seats are locked (i.e. that a foldable rear seat
bench latch is engaged).
• all heavy or sharp-edged objects in the vehicle (e.g. on the parcel shelf) are
secured.
• all persons in the vehicle have their seatbelts fastened.
• the child safety seat is always secured when it is in the vehicle, even if no
child is being transported.
W
• Never use the child safety seat free-standing, not even for test sitting.
• When opening or closing, nothing must come between the seat shell 02
and the seat base 06 . Y
them.
•
T
hard objects (car door
•
Keep the child safety seat in a safe place if it is not in use. Do not place any
heavy objects on the seat and do not store it directly next to sources of heat or
in direct sunlight.
CAUTION! T
•
Certain car seat covers made from more sensitive materials (e.g. velour
er
optimum protection of your car seat covers, we recommend using the BRIT
RÖMER Car Seat Protector from our accessories programme.
6. SAFETY NO
P
7. ANGLE ADJUSTMENT
T
Lift the adjustment handle 17 and pull/push the seat
shell 02 into the desired position.
DANGER! The seat shell 02 must engage secu-
rely regardless of its position. Pull on the seat shell
02 to ensure that it is engaged properly
TIP! Y
02 when your child is sitting in the child seat.
For the safety of your child, before every journey in the car check
that ...
► the child safety seat is securely fastened,
► seat shell 02 and seat base 06 are fully engaged.
marks on the grey release buttons 03 must not be visible.
►the diagonal 21 and the lap seat belt sections 22 run on both sides
through the light red lower belt guides 04 ,
►the diagonal seat belt section 21 runs through the upper dark red belt
guide 01 ,
►diagonal 21 and lap seat belt sections 22 are tight and not twisted,
►the vehicle seatbelt buckle 20 is not positioned between the lower light
red belt guides 04 of the child seat.
►the headrest is adjusted correctly
►the 5-point harness of your child seat are comfortable but FIRM t around
your child,
►the straps of the 5-point harness are not twisted,
►the buckle tongues 23 are engaged in the harness buckle 12 .
DANGER! If your child tries to open the vehicle belt buckle
20
, or the 5-point
harness buckle
12
stop immediately as soon as safely possible. Check
whether the child safety seat is correctly fastened and ensure that your child
is correctly secured. Explain to your child the dangers associated with their
actions.
UNF
T
steps in Section 5 “DISASEMBL [P
02
17
02
03 06
02
06
04
04
20
05
02
06
21
01
06
02
03
16
12
23
12
13
11
10
09
13
11
10
07
09
08
02
16
15
24
15
15
15
16
15
21
22
24
11
DANGER! Batteries for the
● The batteries must be replaced by an adult. ● Keep batteries out of the
reach of children.● Use only new batteries of the same type.● Use only 2x
AAA-
ge.● Remove the old batteries and dispose of them according to the disposal
instructions on page I, chapter 5.● Do not expose the batteries to excessive
heat or re, the batteries may burst or explode.● Due to lower voltage do not
use rechargeable batteries.● Observe the warning on the packaging of your
batteries.
15
