Bedienungsanleitung BroilKing REGAL 690 (Seite 3 von 36) (Englisch)

637964

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

QCC®-1 QUICK CLOSING COUPLING

1. All OMC models are designed to be used with an LP

gas cylinder equipped with the QCC®-1 Quick Closing

Coupling system.

2. The QCC®-1 system incorporates safety features required

by the American National Standards Institute (ANSI) and

the Canadian Standards Steering Committee.

• Gas will not flow until a positive connection has been made.

• A thermal element will shut off the flow of gas between 240°

and 300° F.

• When activated, a Flow Limiting Device will limit the flow of

gas to 10 cubic feet / hour.

3. The LP Gas Cylinder is not included with the Gas Grill.

Be sure to purchase one with the QCC® valve. This valve

is recognized by the external threads on the inlet port of

the valve. QCC® equipped cylinders are available from

your Gas Grill Dealer.

NOTE: Any attempt to connect the regulator, by use of

adapters or any other means, to any other valve could

result in damage, ﬁ re or injury and may negate the

important safety features in the QCC®-1 system.

SPECIFICATION

1. All LP gas cylinders used with this appliance must

be constructed and marked in accordance with the

Specifications for LP Gas Cylinders of the U.S. Department

of Transportation (D.O.T.) or the National Standard of

Canada, CAN/CSA-B339, Cylinders, Spheres and Tubes

for Transportation of Dangerous Goods ; and Commission,

as applicable

2. The LP gas cylinder used for this appliance must not

have a capacity exceeding 20 lb. (9 kg).

• Approximately 18” (46cm) high and 12” (31cm)

diameter

3. All LP gas cylinders used with this appliance should be

inspected at every filling and re qualified by a licensed

service outlet at the expiry date (10 years), in accordance

with the DOT (USA) and Canadian Transport Commission

(Canada) codes for LP Gas Cylinders.

4. All LP gas cylinders used with this appliance must be

provided with a shutoff valve terminating in a cylinder valve

outlet No. 510, specified in the Standard for Compressed

Gas Cylinder Valve Outlet and Inlet Connection (USA)

ANSI/CGA-V-1-1977 (Canada) CSA B96.

5. The cylinder supply system must be arranged for vapor

withdrawal.

6. The cylinder must include a collar to protect the cylinder

valve.

7. The cylinder must be installed as per assembly instructions.

8. Never fill the cylinder beyond 80% full. A fire causing death

or serious injury may occur.

9. The cylinder valve must include a safety relief device

having direct communication with the vapor space of the

cylinder.

HANDLING

1. Government regulations prohibit shipping full LP gas

cylinders. You must take your new cylinder to a LP gas

dealer for filling.

2. A filled LP gas cylinder is under very high pressure. Always

handle carefully and transport in the upright position.

Protect the valve from accidental damage.

3. Do not tip the LP gas cylinder while connecting it to the

regulator. Fasten the cylinder securely during transport,

use and storage.

4. If the cylinder is tipped after it is connected to the regulator,

shut off the gas, disconnect the regulator and have it

checked before using it again.

STORAGE

1. Store the LP gas cylinder outdoors in a well-ventilated

place.

2. Do not store the LP gas cylinder in direct sunlight, near a

source of heat or combustion.

3. If you intend to store the grill indoors, disconnect and

remove the LP gas cylinder first. Disconnected cylinders

must have a dust cap installed and must not be stored in

a building, garage or any enclosed area.

4. Keep out of the reach of children.

5. When the LP gas cylinder is connected to the gas grill, the

gas grill and LP gas cylinder must be stored outside in a

well-ventilated place.

OPERATION

1. Never connect your gas grill to an LP gas cylinder

without the regulator provided, and NEVER TO AN

UNREGULATED LP GAS SUPPLY. The regulator

supplied with the barbecue must be used.

2. Always leak test the LP gas cylinder to regulator

connection when connecting the LP gas cylinder to the

appliance. See “Leak Testing.” (page 5)

3. Do not operate appliance if the smell of LP gas is present.

Extinguish all flame and determine source of LP gas

before proceeding. Do not ignite the appliance until the

LP gas leak has been found and sealed.

4. Always shut off LP gas cylinder valve when the appliance

is not in use.

LP GAS CYLINDER

Nipple with Flow

Limiting Device

Heat Sensitive

Hand Wheel

Regulator

Shut-Oﬀ Valve

Cylinder

Check Valve

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BroilKing REGAL 690 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BroilKing REGAL 690

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info