Bedienungsanleitung Brother MFC-590 (Seite 2 von 6) (Englisch)

451227

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Scanner Cover

Release Lever

PUSH

PUSHPUSH

White Shipping Cover

A. Check that the power is turned on (by plugging in the power cord).

The LCD shows:

CHECK CARTRIDGE

B. Open the Scanner Cover of the MFC by pulling the scanner cover

release lever toward you and lifting the scanner cover. After a few

seconds, the print head will move left to its replacement position.

Opening

Peel in the direction

away from you!

Don't touch

this part

WARNING

If ink gets in your eyes, rinse them with water immediately and if

irritation occurs, consult a doctor.

We recommend that you install the ink cartridges from left to right in

this order: Black, Cyan, Yellow, Magenta.

D. Open the Black ink cartridge bag and take out the ink cartridge.

E. Carefully remove the sealing tape from the bottom of the ink cartridge.

You should peel the tape in the direction

away

from you.

Important

To prevent spilling ink and staining your hands and clothing, peel the

sealing tape gently and slowly. Do not touch the ink opening on the

cartridge or the removed tape.

The MFC starts printing the PRINT QUALITY

CHECK SHEET (only during initial ink cartridge

installation).

Check the sheet to see if the quality and

alignment are OK by following steps A and B.

Check Colour Block Quality and Alignment

Install the Ink Cartridges

STEP A: Colour Block Quality Check

The LCD shows:

1.YES 2.NO

IS STEP “A” OK?

Check the quality of the four colour blocks printed on the sheet.

(BLACK/CYAN/YELLOW/MAGENTA).

If the quality is OK for all colours, press

(YES) to go to

STEP B.

—OR—

If white horizontal lines appear in some colour blocks below,

press

(NO).

OK Poor

The LCD asks you if the print quality is OK for each colour.

1.YES 2.NO

BLACK OK?

Press

(NO) for any colour with a problem.

The LCD shows:

1.YES 2.NO

START CLEANING?

Press

(YES), then MFC starts cleaning the colours.

After cleaning is finished, press

Mono Fax Start. The

MFC starts printing PRINT QUALITY CHECK SHEET again

and goes back to the first step of STEP A.

STEP B: Alignment Check

The LCD shows:

1.YES 2.NO

IS STEP “B” OK?

Check the 600DPI and 1200DPI test print to see if No.5 most

closely matches the OK sample ( 0 ).

If No.5 is the best match, enter

(YES)—OR—

600 DPI

1200 DPI

}

Do NOT select

If another test print number is a better match for either 600DPI

or 1200DPI, enter

(NO) to select it.

For 600DPI, enter the number of the test print that most closely

matches the 0 sample (1-8).

SELECT BEST #

600DPI ADJUST

For 1200DPI, enter the number of the test print that most

closely matches the 0 sample (1-8).

SELECT BEST #

1200DPI ADJUST

• The bottom of the white shipping cover is wet with ink that will cause stains, so wipe it clean before

you place it down.

• Do not throw away the white shipping cover. You will need it for future transportation.

C. Push the four coloured ink cartridge covers one at a time so they pop up. Then remove the white

shipping cover by pulling it toward you and then lifting it up and out.

F. Each colour has its own correct position. Match the colours of the ink cartridge covers, First, gently

insert the Black ink cartridge, and then press the cover down until it clicks.

G. Repeat Steps D-F to install each colour ink cartridge.

H. After installing all ink cartridges, close the scanner cover until it clicks into place. Your MFC will enter a

“head cleaning” cycle for approximately four minutes.

Make sure the paper is loaded in the multi-purpose sheet feeder. The LCD shows CLEANING. After the

cleaning cycle is finished, the LCD shows PRESS FAX START.

I. Press Mono Fax Start and go to Step 8 “Check Colour Block Quality and Alignment”.

Page 2

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Brother MFC-590 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Brother MFC-590

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info