631313
4
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
3/4
Installing the table
1
Loosen the two thumb screws 5 to 6 turns.
2
Position the table so that the notch at the
center aligns with the machine bed, and then
place the table flat on the guide plates.
1 Notch in table
2 Machine bed
3 Guide plate
3
Pull the table toward you slowly, until the
pins on the mounting brackets (attached on
each side to the bottom of the table) fit into
the notches in the guide plates.
1 Pin
2 Notch
4
Slide in the table while supporting it so that
it remains level. Push the table in until it
lightly touches the machine.
If the table does not move smoothly,
slightly lift it up, and then slide it in.
5
While looking below the table, lightly lift it
up, and then lower it so that the screw fits
into the notch at the front of the guide plate.
1 Notch at front
6
Tighten the two thumb screws so that the
table is secured.
1 Thumb screw
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Brother PRWT 1 - Table Set wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info