GB - 24
Disposing of defective or spent batteries
Do not dispose of spent batteries in the domestic waste. According to
the regulations, you must return defective or spent batteries to local
outlets or battery-collection points. Failure to do so is regarded as a
misdemeanour punishable by fine.
Quick-fit chuck
You can fit bits into the quick-fit chuck without using a chuck key.
• Place the direction selector switch (2) into its middle position before fitting drill
or other bits.
• Turn ring B clockwise (as viewed from above or behind) and open the jaws far
enough for the bit to be inserted.
• Insert the bit into the chuck as far as it will go.
• Turn the front part of the chuck anticlockwise close the jaws.
• Make sure that the bit is properly clamped into the chuck while closing it.
OPERATION
Clockwise/anti-clockwise direction of rotation
Use this switch (2) to change the direction of rotation.
• To change the direction of rotation, stop the tool and switch the selector switch
(2) into the required position.
• WARNING: Do not change the direction of rotation while the tool is running.
• Before you start work, make sure that the selector switch (2) is in the right
position, or you may otherwise damage the cordless screwdriver/drill or the bit.
• Switching the selector switch (2) to its middle position locks the on/off switch
(1).
Torque setting
Your cordless screwdriver/drill is equipped with a torque setting for you to be able
to set the right torque for any application.
• Turning the ring (6) will adjust the torque, for example to vary the depth to
which the screw will be screwed in.